POSIFLEX LS-1000 Series, User Manual

FCC Notes: 

This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions manual, 

may cause interference to radio communications. It has been tested and found to comply with limits for a Class A digital device pursuant to EN55022 and 47 
CFR, Part 2 and subpart J of Part 15 of FCC Rules, which are designed to provide reasonable protection against interference when operated in a commercial 

environment. Operation of this equipment in a residential area is likely to cause interference in which case the user at his own expense will be required to 
take whatever measures to correct the interference.

For CE-countries:

This scanner is in conformity with CE standards. Please note that an approved, CE-marked power supply unit should be used in order to 

maintain CE conformance.

Laser Safety:

The laser scanner complies with safety standard IEC 60825 –1 for a Class I laser produce. It also complies with CDRH as applicable to a 

Class IIa laser product.  Avoid long term staring into direct laser light.

Radiant Energy: 

The laser scanner uses one low-power visible laser diodes operating at 650nm in an opto-mechanical scanner resulting in less than 3.9

μ

W 

radiated power as observed through a 7mm aperture and averaged over 10 seconds.
Do not attempt to remove the protective housing of the scanner, as unscanned laser light with a peak output up to 0.8mW would be accessible inside.

Laser Light Viewing:

 The scan window is the only aperture through which laser light may be observed from this product.  A failure of the scanner motor, 

while the laser diode continues to emit a laser beam, may cause emission levels to exceed those for safe operation.  The scanner has safeguards to prevent 
this occurrence.  If, however, a stationary laser beam is emitted, the failing scanner should be disconnected from its power source immediately.

Adjustments:

Do not attempt any adjustments or alteration of this product.  Do not remove the protective housing of the scanner.  There are no user-

serviceable parts inside.

Caution:

 Use of controls or adjustments or performance of procedures other than those specified herein may result in hazardous laser light exposure.

Optical:

The use of optical instruments with this product will increase the eye hazard.  Optical instruments include binoculars, magnifying glasses, and 

microscopes but do not include normal eye glasses worn by the user.

Warranty Limits: 

Warranty terminates automatically when any person other than the authorized technicians opens the machine. The user should consult 

his/her dealer for the problem happened. Warranty voids if the user does not follow the instructions in application of this merchandise. The manufacturer is 

by no means responsible for any damage or hazard caused by improper application.

No part of this document may be reproduced, transmitted, stored in a retrieval system, transcribed, or translated into any language or 
computer language in any form or by any means electronic, mechanical, magnetic, optical, chemical, manual or otherwise, without express 
written consent and authorization.
We reserve the right to make changes in product design without reservation and without notification.  The material in this guide is for 
information only and is subject to change without notice.
All trademarks mentioned herein, registered or otherwise, are the properties of their various respective owners.

About This Manual:

Posiflex Technologies, Inc. has made every effort for the accuracy of the content in this manual. However, Posiflex Technologies, Inc. will assume no 

liability for any technical inaccuracies or editorial or other errors or omissions contained herein, nor for direct, indirect, incidental, consequential or
otherwise damages, including without limitation  loss of data or profits, resulting from furnishing, performance, or use of this material.

This information is provided “as is” and Posiflex Technologies, Inc. expressly disclaims any warranties, expressed, implied or statutory, including without 
limitation implied warranties of merchantability or fitness for particular purpose, good title and against infringement.
The information in this manual contains only essential hardware concerns for general user and is subject to change without notice. Posiflex Technologies,

Inc. reserves the right to alter product designs, layouts or drivers without notification. The system integrator shall provide applicative notices and
arrangement for special options utilizing this product. The user may find the most up to date information of the hardware from: http://www.posiflex.com or 

http://www.posiflex.com.tw or http://www.posiflexusa.com
All data should be backed-up prior to the installation of any drive unit or storage peripheral. Posiflex Technologies, Inc. will not be responsible for any loss 

of data resulting from the use, disuse or misuse of this or any other Posiflex product.
All rights are strictly reserved. No part of this documentation may be reproduced, stored in a retrieval system, or transmitted in any form or by any means, 

electronic, mechanical, photocopying, or otherwise, without prior express written consent from Posiflex Technologies, Inc. the publisher of this
documentation.

©

 Copyright Posiflex Technologies, Inc. 2009

All brand and product names and trademarks are the property of their respective holders.

LS-1000 Series

Laser Barcode Scanner

User’s Manual

Rev. A0

P/N: 18050900030

Page 1