DOWNRIGGER
INSTRUCTIONS
Congratulations on your purchase of the Power-Pole
®
Downrigger.
To add the Power-Pole Downrigger follow these simple step by step instructions.
Knuckle
1/4” Bolts
INSTALLATION
STEP 1
Install the mounting stirrup
Remove the 2, 1/4” bolts from the knuckle of the Power-Pole.
FIG. 1
STEP 2
Attach the Downrigger Stirrup
mount to the knuckle using the
supplied hardware. This hardware needs to go in the correct order to
ensure the stirrup mount does not damage the knuckle or vice versa.
FIG. 2
NOTE:
If attaching to a Power-Pole Blade use long plastic spacer (C)
for all other Power-Pole models use the short spacer.
Proper hardware order:
Flat Washer
A
Stirrup Mount
B
Plastic Spacer
C
Slide the bolt through the knuckle then repeat for the other side.
Tighten the bolts down until they are snug, there is no need to
over-tighten bolts.
Figure 1
Figure 2
B
Stirrup Mount
A
A
C
NOTE:
Use short black spacer (C ) for all
Power-Pole anchors, except Blade
models use the long spacer.
Hardware missing? Need help? Contact our Technical Support Team at
1 + 813.689.9932 Option 2
9010 Palm River Road, Tampa, Florida 33619 phone 813.689.9932 • fax 813.689.8883 • power-pole.com
©2017 all rights reserved. Power-Pole Shallow Water Anchor U.S. Patent No. 6,041,730
