PDS-004 Projector Bracket
Installation Instructions
Page 1
Premier Mounts
3130 E. Miraloma Ave.
Anaheim, CA 92806
Phone: (800) 368-9700 Fax: (800) 832-4888
techsupport@mounts.com www.mounts.com
PDS-004 Projector Bracket Installation Instructions
PDS-004 Bracket
(Qty 1)
M4 x 12mm Phillips
Head Screws
(Qty 3)
1.
Invert the projector and place it on a soft and flat surface. Remove any foot
levelers that might possibly prevent the correct installation of the bracket.
2.
Locate the three mounting points located on the bottom of the projector.
3.
Line up the mounting points on the projector with the mounting holes on
the PDS-004 mounting bracket.
1.
Using a screwdriver, secure the PDS-004 mounting bracket using three (3)
M4 x 12mm Phillips Head screws. Do not over tighten these screws.
Overtightening the screws may result in damaging the threaded inserts on
the projector.
NOTE
:
Please refer the PDS Base Box Installation Instructions to attach the
PDS Base Box to the PDS-004 mounting bracket.
NOTE
:
The projector (shown above) is for illustration purposes only.
M4 x 12mm Security
Head Screws (Qty 3)
IN-PDS004.R0
