background image

534FN

FINISH NAILER

OPERATING INSTRUCTIONS

The Primatech 534FN is a professional heavy duty pneumatic finish nailer designed to drive
standard 34° strips of 15

GA

 nails in lengths of 1-1/4" (32mm) to 2-1/2" (64mm).

Read carefully these instructions before operating this  tool. It is important to understand
warnings/cautions  and  the  safety  measures  to  ensure  safe  use  of  this  tool.  Additional
information is available directly from:

1135 Jérémie-Fortin,

Phone:

1 (800) 363-1962 or 1 (418) 522-7744

Québec,  QC

Fax:

1 (418) 522-7466

Canada, G1J 1R8

email:

support@primatech.ca

web:

support.primatech.ca

IMPORTANT SAFETY INSTRUCTIONS

There are certain applications for which this tool was designed. We strongly recommend that
this tool SHALL NOT be modified and /or used for any application other than for which it was
designed.

WARNING: When using pneumatic tools, basic safety precautions should always be followed
to reduce the risk of personal injury, including the following:

• KEEP WORKING AREA CLEAN. Cluttered areas

invite injuries.

• DON’T ALLOW CHILDREN IN THE WORKING

AREA. Don’t let them handle the tool.

• USE SAFETY GLASSES. To prevent eye injuries,

the tool operator and all persons in the working are
a must wear safety glasses with permanently
attached, rigid, plastic side shields. These safety
glasses must conform to ANSI Z87.1 requirements
(approved glasses have " Z87" printed or stamped
on them).

• USE EAR PROTECTION. The working area may

be exposed to high noise levels that can lead to
hearing damage.

Summary of Contents for 534FN










Reviews: