HEAVIER USE
BOTTLED W
ATER DISPENSER
Quick Start Guide
#601213
WINSTON-SALEM, NC 27101
866-429-7566
WWW.PRIMOWATER.COM
© 2016 Primo Water Corporation
QUICK START GUIDE
1
Place the dispenser on the
floor in the desired location
in your home. If the surface is
uneven, rotate the back feet
to level out the dispenser.
3
Clean probe with a damp
cloth and dish soap. (Visit
www.primowater.com for
detailed cleaning instructions.)
Place probe assembly on hanger
inside door to keep it clean.
2
Slide drip tray into place.
4
Grab a bottle of Primo
®
water and fully remove the cap.
Insert probe assembly into
bottle. Press firmly to secure
assembly over bottle opening.
For 3 and 4-gallon bottles,
squeeze the tabs on the top of
the probe assembly to separate
the probe cap from the collar and
press the collar securely over the
bottle opening.
5
Slide bottle inside the
cabinet and close cabinet door.
6
Plug dispenser into
a ground fault circuit
interrupting (GFCI) outlet.
You will hear the dispenser
begin to pump water to
fill the internal hot and
cold tanks.
7
Turn on desired functions
by flipping the switches on the
back of the dispenser to the
ON position.
Blue – nightlight
Green – chills water
Red – heats water
8
Once the dispenser has
stopped filling the internal
tanks, dispense and dispose at
least 1 quart (approximately
2 pint glasses) of water.
9
Your water will be ready
to dispense fully chilled in
approximately 1 hour or
piping hot in approximately
12 minutes.
10
Register your dispenser
at
www.primowater.com
to
activate your warranty.
Inside of door
1
QT
1
HR
ON
OFF
ON
OFF
ON
OFF
12
MIN
®
®
®
5
Gallon
3
Gallon