background image

PRINCETON TEC EOS II FOR USE IN HAZARDOUS LOCATIONS

ONLY AS TO INTRINSIC SAFETY.

3PRJ

CL I, DIV 1, GR A, B, C, D. TEMP CODE T4. Exia.
WARNING – SUBSTITUTION OF COMPONENTS MAY IMPAIR INTRINSIC SAFETY.
WARNING – TO PREVENT IGNITION OF FLAMMABLE OR COMBUSTIBLE  

 

ATMOSPHERES, DISCONNECT POWER BEFORE SERVICING.
WARNING – TO REDUCE THE RISK OF IGNITION OF A FLAMMABLE OR  

 

EXPLOSIVE ATMOSPHERE, CHANGE BATTERIES ONLY IN AN
  

AREA KNOWN TO BE NON-HAZARDOUS.

WARNING - TO REDUCE THE RISK OF EXPLOSION; DO NOT MIX OLD  

 

BATTERIES WITH USED BATTERIES, OR MIX BATTERIES FROM  

 

DIFFERENT MANUFACTURERS.
APPROVED FOR USE WITH THREE 1.5V AAA BATTERIES, DURACELL MN2400 
OR  ENERGIZER E92.

Princeton Tec cares about the environment and
recommends recycling batteries. For more information
about battery recycling, please go to:
www.batteryrecycling.com
Observe proper battery polarity when installing the
batteries. Improper installation of the batteries will
damage the light and void the warranty.

• Never mix fresh and used batteries.
• Never mix different battery brands or  

 

chemistry types.
• Always remove drained batteries immediately.
• Remove batteries during long periods of  

 

 storage.
NOTE: Lithium batteries offer extended 
constant brightness time, extreme cold weather 
performance, and are lighter weight. Recharge-
able NiCad or NiMH batteries may result in 
reduced brightness due to lower nominal 
voltage. 
The EOS II battery compartment has a 
waterproof seal. It is important to keep this seal 
free from dirt and away from harsh chemicals in 
order to preserve waterproof integrity. Inspect 
the seal every time batteries are changed. If dirt 
is present, wipe gently with a damp cotton 
swab and mild soap until dirt is removed. 
NOTE: Some battery types can emit hydrogen 
gas, which can create an explosion potential in 
sealed devices if it is not vented or removed. 
The EOS is equipped with a platinum catalyst 
to remove this gas. Upon severe impact, the 
catalyst could fracture. If you notice a rattling 
sound in the headlamp or gray particles in the 
battery compartment, do not use the 
headlamp. See the warranty and return policy 
for more information.

Switch Operation - See Switch Operation 

Diagram
Modes (High and low) are selected by pressing 
and releasing the button within 1.5 seconds of 
the previous button press.
To turn the EOS II off, press and hold until the 
light turns off.

Troubleshooting
If the EOS II fails to light: 
• Check the batteries for proper installation.
• Replace batteries if proper installation is 
confirmed.

• Check circuit board for water (the seal may 
have been compromised by improper rear 
cover installation). The light will resume normal 
operation once the water is shaken or blown 
out and the light is left open until completely 
dry. If the light has been contaminated with salt 
water, flush the unit with fresh water and dry as 
described above.

USA Lifetime Warranty - International 10-Year 

Warranty
Due to International regulations, Princeton 
Tec's lifetime warranty can only be offered to 
customers in the USA. Princeton Tec offers a 
10-year warranty to our customers outside the 
USA.  FULL WARRANTY - Princeton Tec 
warrants this product to be free from defects in 
workmanship and materials under normal use 
for as long as you own this product. This 
warranty covers all of the component parts of 
the product except batteries. This warranty 
does not cover deterioration due to normal 
wear or damage due to misuse, alteration, 
negligence, accidents, or unauthorized repair. 
Princeton Tec will repair or replace parts which 
are defective In workmanship or materials. Your 
authorized Princeton Tec Dealer and Princeton 
Tec are the only facilities authorized to repair 
the product. After (3) unsuccessful attempts to 
repair the product, you have the right to elect 
replacement of the product 
or a refund of the purchase price less 
allowance for use of the product. NO 
INCIDENTAL OR CONSEQUENTIAL DAMAGES 
ARE INCLUDED IN THIS WARRANTY. (Some 
states do not allow the exclusion or limitation of 
incidental or consequential damages, so the 
above limitations or exclusions may not apply 
to you.) 
This warranty gives you specific legal rights, 
and you may also have other rights which vary 
from state to state. 
Princeton Tec reserves the right to change 
product specifications without notice.

FOR CALIFORNIA RESIDENTS:
WARNING: This product contains Bisphenol A 
(BpA) a chemical known to the State of 
California to cause birth defects or other 
reproductive harm.

Return Policy
If your light fails to operate, follow these 
simple steps:
1) Check batteries. Replace if necessary.
2) To send your light in for repair or replace-
ment, first contact Princeton Tec customer 
service on 

1-800-257-9080 to request an RMA 

number. Please have your light model, date of 
purchase and a brief description of the fault 
you are experiencing. No warranty repairs will 
be accepted without an RMA number.
3) Return the light without batteries to: 
Princeton Tec, PO Box 8057 Trenton NJ 
08650 
Postage due and freight collect items 
will not be accepted.
4) Upon receipt your light will be processed in 
about two weeks. Please allow additional time 
for return transportation from New Jersey.

INTRINSIC

ALL

Y S

AFE 

LED HEADLAMP

• Alkaline (LR03)

• LITHIUM (L92)

• Lithium batteries may be used, 

  but have not been approved by UL

0517

Princeton Tec
PO Box 8057, Trenton, 
NJ 08650
Phone: 609-298-9331
Fax: 609-298-9601
www.princetontec.com
© 2017 Princeton Tec 

108H

80 H

23

65

EOS II

FINISHED FOLD SIZE - 2.5” X 1.125”

Reviews:

Related manuals for EOS II