© 2019 Ferguson Enterprises, Inc. All Rights Reserved.
Distributed exclusively by Wolseley North American Division: Ferguson, Stock Building Supply and Wolseley Canada.
Installation Instructions
HET ONE PIECE TOILET
Remove Old Toilet
a. Close toilet supply valve and flush tank
completely. Towel or sponge remaining water
from tank and bowl.
b. Disconnect and remove supply line
NOTE: If replacing valve, first shut off main
water supply!
c. Remove old mounting hardware, remove toilet
and plug floor waste opening to prevent escaping
sewer gases.
Installation Procedures
1. Install Closet Flange Bolts
Install closet flange bolts in to the flange channel
turning the head of the bolt 90°
and slide in to place, they will be spaced 6”
(152mm) apart and parallel to the wall.
2. Install Wax Ring Seal
Lay toilet on to its side (use cardboard to cushion
the ceramic and prevent damage). Install the wax
ring evenly around the waste flange horn. Place a
bead of sealant on bottom of toilet foot.
3. Position Toilet on the Flange
Unplug floor waste opening and install the toilet
on to the closet flange aligning the flange bolts
“A” through both mounting holes on the toilet foot.
Loosely install the bolt cap retainer washer, brass
washer and nut on to the flange bolts “A”.
4. Install Toilet
Position the toilet so the tank will align evenly with
the wall, use a rocking motion and press down
firmly on the center of the bowl pressing it to the
floor. Alternately tighten the flange nuts until the
bowl is seated to the floor. Cut flange bolt above
the nut and install the bolt caps. Remove and
smooth excess sealant around foot.
5. Water Supply Connection
Connect the flexible supply line from the stop
valve to the toilet fill valve.
DO NOT USE SEALANTS
ON SUPPLY FITTINGS!
Hand tighten supply line,
then open stop valve and
CHECK CLOSELY FOR
WATER LEAKS!
Tools Needed
A. Screwdriver
B. Wrench
C. Tape Measure
D. Level
E. Drill
F. Flange
G. Wax Seal
H. Marker
I. Flexible
Supply Line
16159 0613
Wa
Rubbe
Plastic
!
