background image

V 1.0

Made in China

CHOKING HAZARD - Small parts. 

Not suitable for children under 3 years.

WARNING!

13

WARNING: Never leave product charging unattended for extended periods of

time. Always disconnect the battery from charger immediately after the battery

is fully charged. Please refer to enclosed safety instructions.

INSTRUCTION BOOKLET

PACKAGE CONTAINS:

Colors and styles may vary.

FCC Part 15 C Notice

CAUTION: Changes or modifications not expressly approved by the party responsible for compliance could 
void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, 
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against 
harmful interference in a residential installation. This equipment generates, uses and can radiate radio 
frequency energy and, if not installed and used in accordance with the instructions, may cause harmful 
interference to radio communications. However, there is no guarantee that interference will not occur in a 
particular installation. If this equipment does cause harmful interference to radio or television reception, 
which can be determined by turning the equipment off and on, the user is encouraged to try to correct the 
interference by one or more of the following measures:
•    Reorient or relocate the receiving antenna.
•    Increase the separation between the equipment and receiver.
•    Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
•    Consult the dealer or experienced radio/TV technician for help.

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions : 
(1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause 
    undesired operation.

2.4G Wireless Controller

Instruction Manual

Spare Parts

AIR RACER™ 2.0

USB Charger 

& Li-Poly 

Rechargeable Battery

IM

Conforms to safety requirements of FCC. 

This product is manufactured by AMAX Group

12645 Memorial Drive Suite F1 #388 Houston, TX 77024

Propel™ and Propel RC™ are the licensed trademarks of Rooftop Group 

LTD Singapore.

2008 All rights reserved. Visit us at www.propelrc.com

FPO

ARTWORK NO.

DESCRIPTION

MDSER

DESIGNER

DATE

114 x 174MM

Johnny

2019/05/22

Indoor / Outdoor Laser Battling Drones

AIR RACER

 2.0

Summary of Contents for AIR RACER 2.0








Reviews: