background image

`

DESCRIPTION

QTY

Molle Front Plate

 1

Molle Side Plates 

 2

Front Upper Brackets 

 2

Front Lower Brackets 

 2

Single-Flange Side Mounting Brackets

 2

Double-Flange Side Mounting Brackets

 2

M6 Torx-Head Bolt

 20

Rubber Feet

 3

Jam Nuts

 3

3/4” Well Nut

 2

3/8”-16 X 1.5” Allen Head Bolt

 2

5/16”-18 X 2 3/8” Allen Head Bolt

 2-4

In-Bed Washer

 2-4

Nut Plate

 2-4

Flat Brackets – for 8-foot beds

 2

Congratulations on your purchase of a high quality PUTCO

®

 product. Should 

you need any application or technical assistance, feel free to call us at: 

Monday-Friday 8:00am - 5:00pm (Central Standard Time) 

Contact your PUTCO

®

 dealer for other quality accessories.

1956XXI

1-800-247-3974

PLEASE READ ALL INSTRUCTIONS BEFORE INSTALLATION 

AND CHECK TO SEE THAT ALL PARTS ARE INCLUDED

CONTENT LIST

REQUIRED TOOLS

INSTRUCTION GUIDE

RAM 2500/3500

3/16” HEX KEY

7/32” HEX KEY

10MM WRENCH

5MM WRENCH

T30 TORX DRIVER

Summary of Contents for MOLLE PANELS RAM 2500

Page 1: ...late 2 4 Flat Brackets for 8 foot beds 2 Congratulations on your purchase of a high quality PUTCO product Should you need any application or technical assistance feel free to call us at Monday Friday 8 00am 5 00pm Central Standard Time Contact your PUTCO dealer for other quality accessories 1956XXI 1 800 247 3974 PLEASE READ ALL INSTRUCTIONS BEFORE INSTALLATION AND CHECK TO SEE THAT ALL PARTS ARE ...

Page 2: ...ory hardware Refer to the picture on page 3 5 6 Next gather the two Front Upper Brackets Loosely assemble one 2 3 8 long Allen head bolt In Bed Washer and Nut Plate onto each of these brackets Install the Front Upper Bracket assemblies by inserting the Nut Plate into the slot located towards the top of each bed side as shown in the pictures on the next page The nut plate will have to be inserted a...

Page 3: ...e rubber feet into the riv nuts located on the bottom flange of the front plate Next locate the two remaining Front Lower Brackets Loosely assemble a 3 4 inch well nut and 1 5 inch long Allen head bolt onto each bracket Install the lower bracket assemblies by inserting the well nut into the slot located just next to the forward tie down hook Tighten the bolt using a 7 32 hex key until the well nut...

Page 4: ...nt plate down until they are snug against the bed floor then lock the feet in place by tightening the jam nut against the front plate using a 10mm wrench Now that everything is installed ensure that all fasteners have been tightened until snug but do not overtighten Your new MOLLE Panels are now successfully installed on your vehicle Completed Molle Panel kit for Ram 2500 3500 ...

Reviews: