background image

- 4 -

INSTRUCTION MANUAL

www.pyleaudio.com

02'(/36/;;;;

5(*8/$7(''&
32:(5 6833/<

OPERATION:

1  INSERT AC POWER PLUG INTO A 110V VOLT AC OUTLET.
2  CONNECT THE POWER CORD OF YOUR EQUIPMENT (13.5V-14.1VDC) TO THE 

OUTPUT BINDING POST TERMINALS ON THE FRONT OF THE UNIT BE SURE THAT 
POLARITY IS CORRECT THE RED POSITIVE (+) TERMINAL AND BLACK NEGATIVE 
(-) TERMINAL ARE MARKED. REVERSAL OF POLARITY MAY DAMAGE YOUR 
EQUIPMENT.

3  TURN SWITCH TO “ON”, RED LIGHT  IN SWITCH WILL ILLUMINATE.
4  THE INPUT POWER IS PROTECTED BY THE FUSE WHICH IS LOCATED AT THE REAR 

OF THE UNIT AND CAN BE REPLACED BY UNSCREWING THE FUSE HOLDER IF 
THE FUSE IS BURNT OUT.  DO NOT USE A FUSE LARGER THAN …  AMPS USE OF 
HEAVIER FUSE MAY RESULT IN DAMAGING TO THIS UNIT (… SEE NOTE)

5  THIS UNIT HAS ELECTRONIC OVERLOAD PROTECTION WITH INSTANT AUTOMATIC 

RESET FUNCTION. IF OUTPUT IS OVERLOADED. THE OUTPUT POWER WILL 
AUTOMATICALLY SHUT OFF. RELEASE POWER CORD OF YOUR EQUIPMENT 
FROM THE OUTPUT TERMINALS AND CHECK THE ACTUAL POWER RATING OF 
YOUR EQUIPMENT THIS UNIT WILL AUTOMATICALLY RESET INSTANTLY.

6  OVER TEMPERATURE PROTECTION CIRCUITRY IS USED IN PSL32X/42X/ 

72X/82X TO PREVENT OVER HEAT DAMAGE UNIT WILL BE SHUT DOWN 
MINUTES AFTER 15 MINUTES( MIN. ) AT 100% RATED LOAD.

                                    25  MINUTES(  MIN.  )  AT  80%  RATED  LOAD.
… NOTE    PSL32X: 1.5 AMP
                  PSL42X: 1.0

AMP

                  PSL72X : 1.5 AMP
                  PSL82X: 1.5

AMP

CAUTIONS:

1. DO NOT USE WITH EQUIPMENT REQUIRING MORE THAN RATING AMPS
2. DO NOT USE OUTDOORS DO NOT EXPOSE UNIT TO RAIN, MOISTURE, WATER OR 

ANY OTHER LIQUIDS.

3. DO NOT REMOVE COVER IN ANY CASE. RETURN TO DEALER FOR REPAIR IF 

DAMAGED.

4. THIS UNIT HAS A SPECIAL BUILT-IN FEATURE THAT WILL SHUT THE UNIT DOWN 

IF MARKED AMPERAGE IS EXCEEDED. THIS WILL AVOID BURN-OUT OF YOUR 
EQUIPMENT AND OF UNIT. IF UNIT DOES CONSISTENTLY SHUTDOWN. THIS 
MEANS YOU ARE DRAWING TOO MUCH AMPERAGE RETURN UNIT TO PLACE 
OF PURCHASE AND UPGRADE TO NEXT AVAILABLE UNIT OFFERING HIGHER 
AMPERAGE. PLEASE DO NOT BYPASS OR ALTER THIS CIRCUIT AS IT IS THERE TO 
PROTECT YOU.  ANY ALTERATION OR MISUSE WILL VOID YOUR WARRANTY.

“DANGER”

HIGH VOLTAGE

REFER TO QUALIFIED TECHNICIAN FOR SERVICE.

Reviews: