![background image](http://html1.mh-extra.com/html/qualitycraft/mcvt120-150/mcvt120-150_quick-start-manual_769792001.webp)
1
Model: MCVT120-150
PLUG IN CoNveCtIoN heater
wIth bUILt-IN ProGraMMabLe
therMostat
IMPORTANT
PleAse NOTe WheN yOu OPeN The CARTON CARefully CheCk The uNIT
ANd MAke suRe TheRe Is NO dAMAge. If yOu hAVe ANy PRObleMs WITh
The uNIT, WITh hOW The VARIOus fuNCTIONs WORk, dAMAged OR MIssINg
PARTs PleAse CAll 1-800-459-4409 (9 AM TO 5 PM esT) IMMedIATely fOR
seRVICe.
NOTe: dO NOT ReTuRN uNIT TO The sTORe befORe CAllINg The TOll fRee
NuMbeR. dO NOT dIsPOse Of yOuR CARTONs uNTIl yOu ARe COMPleTely
sATIsfIed WITh yOuR NeW CONVeCTOR heATeR.
INstrUCtIoN MaNUaL
ATTeNTION:
1. Find a location for the convection heater that is protected from direct sunlight.
2. Do not plug the unit into the power outlet before reading all instructions.
IMPortaNt saFetY INstrUCtIoNs
WheN usINg eleCTRICAl APPlIANCes, bAsIC PReCAuTIONs shOuld AlWAys
be fOllOWed TO ReduCe The RIsk Of fIRe, eleCTRIC shOCk, ANd INJuRy
TO PeRsONs, INCludINg The fOllOWINg:
1) Read all instructions carefully before using the heater.
2) This heater is hot when in use. To avoid burns, do not let bare skin touch
hot surfaces. If provided, use handles when moving this heater. keep
combustible materials such as furniture, pillows, bedding, papers, clothing
and curtains at least 3 feet (0.9 m) away from front, sides and rear of the
heater.
3) extreme caution is necessary when any heater is used by or near children
or individuals with disabilities and whenever the heater is left operating and
unattended.
4) do not operate the heater with a damaged cord or plug or if the heater
malfunctions, has been dropped or damaged in any manner. disconnect
power at service panel and have heater inspected by a qualified electrician
before use.
5) do not use outdoors.
6) This heater is not intended for use in bathrooms, laundry areas or in wet
or moist indoor locations. Never place the heater where it may fall into a
bathtub or other water containers.
7) To disconnect the heater, turn controls to Off then remove plug from outlet.
8) do not insert or allow foreign objects to enter any ventilation or exhaust
openings as this may cause an electric shock, fire or may damage the heater.
do not use on soft surfaces, such as a bed where openings may become
blocked.
9) To prevent possible fire, do not block air intakes or exhaust in any manner.
10) heaters may have hot and sparking parts inside. do not use it in areas where
gasoline, paint or flammable liquids are used or stored.
11) use this heater only as described in this manual. Any other use not
recommended by the manufacturer may cause fire, electric shock or injury to
persons.
12) do not run the electric cord under carpeting. do not cover the cord with
throw rugs, runners or similar coverings. do not place the cord in a traffic
area.
13) Always plug heater directly into a wall electrical outlet. Never use with an
extension cord or power bar.
14) Always unplug heater when not in use.
15) Connect to properly grounded outlets only.
16) Avoid the use of extension cord as the cord may overheat and cause a risk of
fire. however, if you must use an extension cord, the plug must be a grounding
type, 3-wire cord, No. 14 AWg minimum size and rated not less than 1875
watts.
save these INstrUCtIoNs For FUtUre Use.
WARNINg:
PROCeduRes ANd TeChNIques If NOT CARefully fOllOWed WIll ResulT
IN dAMAge TO The equIPMeNT ANd WIll exPOse The useR TO The RIsk Of
seRIOus INJuRy, IllNess OR deATh.
ThIs heATeR Is fOR use ON 120 VOlTs. The CORd hAs A Plug As shOWN
AT A IN IllusTRATION belOW. AN AdAPTeR As shOWN AT C Is AVAIlAble
fOR CONNeCTINg ThRee-blAde gROuNdINg-TyPe Plugs TO TWO-slOT
ReCePTACles. The gReeN gROuNdINg Plug exTeNdINg fROM The AdAPTeR
MusT be CONNeCTed TO A PeRMANeNT gROuNd suCh As A PROPeRly
gROuNded OuTleT bOx. The AdAPTeR shOuld NOT be used If A ThRee-slOT
gROuNded ReCePTACle Is AVAIlAble.
GeNeraL INForMatIoN
This convection heater is intended for permanent wall-mounting with the provided
brackets.
The heater has a thermal cut-off protection. If the thermal cut-off protection trips, switch
off the power. The unit should reset automatically after 10 minutes. If the thermal cut-off
protection trips again, determine the reason for overheating.
sPeCIFICatIoNs
MOdel
VOlTs
WATTs heIghT WIdTh dePTh
MCVT120-150
120VAC
1500W
443MM
581MM
112MM
Summary of Contents for MCVT120-150
Page 5: ...5 ...