1. Attach coolant lines to the back of the
laser head and back of the power sup-
ply:
blue to blue
and
red to red
.
2. Attach the double-connector side of the
electrical cable to the laser head.
These connectors have red dots indi-
cating proper orientation. Note:
It is
easier to attach the bottom connector
first
. Ensure that the connectors are
fully seated. Note:
You should hear an
audible “click”
.
3. Attach the other end of the D-Connector to the back of the power supply
and
tighten the thumb screws
completely to avoid connector contact
damage. Note:
Never operate the laser system without the connectors
of the electrical cable fully inserted and the thumbscrews tightened.
•
The optional External DI Cartridge instructions are on the oppo-
site side of this Quick Start Guide.
4. Connect the power cord to the back of the power supply.
5. Remove white plastic shipping cover from the front of the laser head.
Do not discard.
Quick Start Guide For Your ULTRA Laser System
WARNING
: THIS IS A CLASS IV LASER. READ AND FOLLOW YOUR USER’S MANUAL BEFORE OPERATING TO AVOID DAMAGE OR PERSONAL INJURY.
ULTRA Laser Head/Rack Power Supply
1
UNPACK
your system. Save your packing material.
Locate the following items:
Laser Head
Rack Power Supply with Fill Kit
Coolant Lines and Electrical Cables
Accessory Kit (
including keys
)
Power Cord
Coolant (Distilled Water)
External DI Cartridge (
optional
)
WARNING
: OPERATING YOUR LASER WITHOUT COOLANT WILL CAUSE CATASTROPHIC FAILURE.
2
3
DOC00073 Rev A
CABLE CONNECTION
FILL
Electrical Cables
Coolant Lines
1. Attach vent hose to the
upper
vent port
on the front of the power supply as
shown.
2. Attach the fill bottle to the
lower
fill port
on the front of the power supply.
3. Add water to the fill bottle until the cool-
ant begins to drain from the vent hose.
Note:
You may need to loosen the cap on
the fill bottle to generate flow.
4. Ensure that the red emergency stop but-
ton on the front of the power supply is
rotated to the OUT position.
5. Turn the key to the ON position. The pump will start.
6. Add coolant until coolant remains at the top of the
view window. Note:
To check the water level, it
may help to tilt or move the power supply.
7. To purge the laser head of trapped air, turn the key
OFF for approximately 30 seconds allowing
trapped air to collect. Turn the key ON to
start the pump. Note:
This may take 3-5 attempts.
8. If possible, tip the laser head up and down to dislodge any trapped air.
Note:
You shouldn’t see any bubbles in the coolant lines.
9. Disconnect the fill bottle and vent hose.
10. Turn the key to the OFF position.
11. Secure the laser head to the table using three 8-32 UNC screws at
torque 16-18 in-lb.
(OVER)
Vent Port
Fill Port
Vent Hose
Fill Bottle
View Window
Emergency Stop Button
