The iSTART Li-Ion Power Pack is a compact, hand-held, power
source for charging or supplying power to most 12V or 19V
electronic devices. It’s also powerful enough to jump start a
12 volt gasoline engine on a car, truck, motorcycle, ATV or
watercraft.
Prior to use, test the iSTART Li-Ion Power Pack’s battery level
by depressing the power button and refering to chart below.
Recharge every 30 days or when the capacity indicator lights
indicate low charge. Fluctuations in temperature can
accelerate battery discharge. Check your unit often.
Charging the iSTART Li-Ion Power Pack
NEVER USE ANY CHARGING DEVICES OTHER THAN THE
AC AND DC CHARGING DEVICES INCLUDED WITHIN, OR
DAMAGE MAY RESULT!
The iSTART Li-Ion Power Pack can be charged either with the
AC wall socket charger or the 12 volt DC power plug adapter
included.
Throughout the charge cycle, the capacity indicator lights will
flash one by one. During charging, each light will glow solid as
the unit charges. Once all lights are glowing solid, the unit is
then fully charged.
To charge mobile phones or other USB devices:
IMPORTANT: Verify that your mobile phone or device
will accept a 5 volt charge rating.
1) Insert your mobile phone or other device’s USB cable to the
5 volt USB output port (#5) of the iSTART Li-Ion and continue
to step 4.
2) If a charge cord is unavailable, select the USB cord (white
#13) and insert it into the 5 volt USB output port (#5) of the
iSTART Li-Ion.
3) Select the correct connector tip (white #13) for your mobile
phone or other device and connect it to your device.
4) Depress the power button on the iSTART Li-Ion to begin
charging or supplying power.
To charge laptops or notebooks:
IMPORTANT: Verify that your laptop or notebook
will accept a 19V charge rating.
1) Insert the adapter cord (black #12) into the 19 volt output
port (#3) of the iSTART Li-Ion Power Pack.
2) Select the correct laptop cable tip (black #11) for your
laptop or notebook, attach it to the adapter cord (#12), and
connect to your device.
3) Depress the power button on the iSTART Li-Ion to begin
charging or supplying power.
IMPORTANT: Make sure the iSTART Li-Ion Power
Pack is fully charged or has no less than 4 capacity
indicators illuminated. DO NOT connect (#8)
jumper clamps to the unit until they are
first connected to the battery.
Connect the red (po) jumper clamp to the positive
terminal of the battery and connect the black (negative –)
jumper clamp to the negative terminal of the battery and
make sure there is a good connection.
Insert the blue connector plug of the jumper clamps into
the iSTART Li-Ion Power Pack and fully insert it until the
shoulder of the plug rests on the case.
Start the vehicle and leave it running.
Disconnect the blue connector plug from the iSTART Li-Ion
Power Pack IMMEDIATELY.
WARNING – Damage may occur if the iSTART is attached
to a running vehicle for more than 30 seconds after the
engine starts.
Remove jumper cables from battery and return unit to case
for storage.
To use the 12 volt output port
The 12 volt output port can be used for portable DVD, cameras,
gaming devices, or other 12 volt electronics that require up to a
10A power source.
• Always use care when using this product.
• Do not use the power pack if any cable clamp or cord is
damaged.
• Do not short circuit the unit. Don’t touch the clamps together
or to any conductive material.
• Disconnect the blue connector plug from the iStart Li-Ion
Power Pack IMMEDIATELY. Damage may occur if the iStart is
attached to a running vehicle for more than 30 seconds after
the engine starts.
• If your iStart Li-Ion power pack requires service, follow the
directions in the warranty section. Do not attempt to open or
repair the unit. Unauthorized repairs will void your warranty.
• Check vehicle battery terminals before using the power pack;
clean them if necessary.
• Only jump start when 4 to 5 indicator lights are illuminated.
• After approximately 10 seconds of continuous cranking, if the
disabled vehicle fails to start, stop and wait for 2 minutes.
This prevents damage to your power pack and to your
vehicle’s system.
• This appliance is not intended for use by young or infirm
persons without supervision.
• Do not use as a toy.
• Do not allow the appliance to become wet.
• Do not submerse the appliance in water.
• Do not operate the appliance in explosive atmospheres, such as
in the presence of flammable liquids, gases, or dust.
• Do not expose the appliance to heat.
• Do not store in locations where temperatures may exceed 70°C.
• Charge only at ambient temperatures between 0°C and 60°C.
• Charge only using the charger provided.
To use the LED Flashlight
The LED flashlight has multiple modes that allow it to be used
as a flashlight, a strobe light or an S.O.S. distress light.
1.
1.
2.
2.
3.
3.
4.
5.
6.
7.
8.
1.
2.
3.
4.
5.
1.
2.
3.
4.
5.
9.
10.
11.
12.
13.
14.
Hi Power LED Flashlight
Jump Start Port
19V Laptop Output Port
Capacity Indicators
5V USB Ouput Port
12V Output Port
Input Charge Port
Jumper Clamps
Wall Charger (AC)
12V Power Plug Charger (DC)
Laptop Cable Tips
Adapter Cord (black)
USB Cable & Cell Phone Tips
Carrying Case
4.
5.
6.
7.
8.
9.
12.
14.
13.
10.
11.
Operators Guide
To jump start a 12 volt gasoline engine vehicle:
NOTICE: While in use, this unit can generate heat and
it is recommended to use in a well-ventilated area.
If the unit becomes HOT to the touch, disconnect
and allow it to cool.
1.
2.
3.
Insert the adapter cord (black #12) into the 12 volt output
port (#6) of the iSTART Li-Ion Power Pack.
Connect the other end to your device.
Depress the power button on the iSTART Li-Ion Power
Pack to begin charging or supplying power.
1.
2.
3.
4.
Depress the power button on the iSTART Li-Ion Power Pack
and hold for 3 seconds to illuminate the flashlight mode.
Depressing the button a second time will initiate the strobe
mode.
Depressing the button a third time will initiate the S.O.S.
distress mode.
Depressing the button again will turn the light off.
1. Failure to follow these instructions may result in personal injury,
destruction of the power pack, or damage to your vehicle.
2. Read owner’s manual before use.
3. Wear safety goggles whenever working around vehicle batteries.
4. Wear gloves and protective clothing.
• Failure to keep internal battery charged will lead to permanent
battery damage.
• Connecting a discharged battery to charged system could cause
overheating or explosion.
Risk of Battery Explosion, Fire or Failure
WARNING – Risk of Explosion or Fire
The Manufacturer warrants this product against defects in material and workmanship for one (1)
year from the date of original retail purchase. Quick Cable will, at its option, repair or replace
defective units.
Quick Cable encourages you to register your product at www.quickcable.com/register and to retain
your original sales receipt with this manual for warranty purposes.
Damage caused by misuse or improper connections, failure to follow prescribed operating
instructions, impact damage, or negligence is not covered by this warranty. The manufacturer
reserves the right to inspect units for improper use in determining warranty coverage.
EXCEPT FOR THIS LIMITED WARRANTY, THE MANUFACTURER HAS NOT MADE AND
SPECIFICALLY DISCLAIMS ANY WARRANTY OR REPRESENTATION OF ANY KIND, EXPRESS OR
IMPLIED, DIRECT OR INDIRECT, INCLUDING BUT NOT LIMITED TO ANY IMPLIED WARRANTY OF
MERCHANTABILITY, AND ANY IMPLIED WARRANTY OF FITNESS FOR A PARTICULAR PURPOSE.
THIS LIMITED, CONDITIONAL WARRANTY PROVIDES THE EXCLUSIVE REMEDY FOR ANY CLAIM
OR DAMAGE EXCEPT AS OTHERWISE REQUIRED BY LAW.
This warranty excludes and does not cover defects or failures of your POWER PACK due to any
cause other than defects in material or workmanship, including without limitation any malfunctions
or failures caused by repairs made by an unauthorized person, mishandling, modifications, normal
wear, improper storage and unreasonable use or damage.
IN NO EVENT SHALL THE MANUFACTURER BE LIABLE FOR CONSEQUENTIAL OR INCIDENTAL
DAMAGES. Some states do not allow the exclusion or limitation of incidental or consequential
damages so the above limitations or exclusions may not apply to you. This warranty gives you
specific legal rights and you may also have other rights which vary from state to state.
Any claim relating to the Portable Power Pack must be submitted within one (1) year of purchase
and must be sent to Quick Cable in the U.S.A or Canada.
If any portion of this warranty or limitation of rights and remedies is found to be unenforceable,
then the remainder of this document shall remain in full force and effect.
1. Call Technical Service toll free in U.S.A. 1 (800) 558-8667 or in Canada 1 (800) 728-1742. Have
your power pack near the phone and a technician will help you diagnose the problem.
2. Be prepared to establish proof and date of purchase.
3. Any misuse of this unit will void this warranty.
Limited warranty
To obtain service under this warranty:
Size:
Weight:
Output:
Input:
Charge Time:
Starting Current:
Peak Current:
Operating Temperature:
Storage Temperature:
160*75*28mm
414g / 14.5 oz.
2A @5V DC / 10A @ 12V DC / 3.5A @ 19V DC
1A @ 14V DC
Approx. 3 to 4 hours – empty to full
225A
425A
-20°C to 60°C
Store unit at or above 0°C (32°F) as batteries
will discharge faster at colder temperatures.
Technical Specifications
Use your iStart safely
