LFLED INSTALLATION INSTRUCTIONS
IMPORTANT
READ CAREFULLY BEFORE INSTALLING FIXTURE. RETAIN THESE INSTRUCTIONS FOR FUTURE REFERENCE
.
RAB fixtures must be wired in accordance with the National Electrical Code and all applicable local codes. Proper
grounding is required for safety. THIS PRODUCT MUST BE INSTALLED IN ACCORDANCE WITH THE APPLICABLE
INSTALLATION CODE BY A PERSON FAMILIAR WITH THE CONSTRUCTION AND OPERATION OF THE PRODUCT
AND THE HAZARDS INVOLVED.
WARNING:
Make certain power is OFF before installing or maintaining fixture. No user serviceable
parts inside.
Thank you for buying RAB lighting fixtures. Our goal is to design the best quality products to get the job done right. We’d like to hear your comments. Call
the Marketing Department at 888-RAB-1000, or email: marketing@rabweb.com
WALL MOUNTING
Mount to a weatherproof junction box and cover plate
(not supplied) as shown. To ensure weatherproof seal,
apply weatherproof silicone sealant around the edge of
the wall cover plate or surface box. This is especially
important with an uneven wall surface.
1.
Seal arm thread using Teflon tape or silicone sealant.
2.
Thread fixture into
Cover Plate
(not supplied).
3.
Connect wires as shown in the wiring diagram.
4.
Attach cover plate to
Junction Box
(not supplied).
5.
Aim floodlight in the direction desired and tighten
locknut and
Arm Screw
.
Cover Plate
(not supplied)
GROUND MOUNTING
Mount to a Mighty Post (RAB Cat# MP19) as shown.
1.
Thread fixture into
Mighty Post Cap
.
2.
Connect wires as shown in the wiring diagram and
place inside the
Mighty Post
.
3.
Place
Mighty Post Cap
on the
Mighty Post
.
4.
Aim floodlight in the direction desired and tighten
locknut and
Arm Screw
.
Junction Box
(not supplied)
Mighty Post
Cap
Mighty Post
Arm Screw
LF Flood
LF Spot
Note: These instructions do not cover all details or variations
in equipment nor do they provide for every possible situation
during installation, operation or maintenance.
Arm Screw
