Thank you for buying RAB lighting fixtures. Our goal is to design the best quality products to get the job done right. We’d like to hear your comments.
Call the Marketing Department at 888-RAB-1000 or email: marketing@rabweb.com
VXLED INSTALLATION INSTRUCTIONS
IMPORTANT
READ CAREFULLY BEFORE INSTALLING FIXTURE. RETAIN THESE INSTRUCTIONS FOR FUTURE REFERENCE
.
RAB fixtures must be wired in accordance with the National Electrical Code and all applicable local codes. Proper grounding
is required for safety. THIS PRODUCT MUST BE INSTALLED IN ACCORDANCE WITH THE APPLICABLE INSTALLATION CODE BY A
PERSON FAMILIAR WITH THE CONSTRUCTION AND OPERATION OF THE PRODUCT AND THE HAZARDS INVOLVED.
WARNING:
Make certain power is OFF before installing or maintaining fixture. No user serviceable
parts inside.
Housing
Housing
Screws(2)
Housing-
Gasket
Inner
Globe
Globe
Gasket
Outer Globe
(purchase
separately)
Guard
(purchase
separately)
WIRING
Universal voltage driver permits operation at 120V thru
277V, 50 or 60 Hz.
1.
Connect the black fixture lead to the (+) LINE
supply lead.
2.
Connect the white fixture lead to the (-) COMMON sup-
ply lead.
3.
Connect the GROUND wire from fixture to
supply ground.
Note: These instructions do not cover all details or variations in
equipment nor do they provide for every possible situation during
installation, operation or maintenance.
CEILING MOUNT
Fixture must be ceiling mounted. Use a recessed or surface
mount junction box (not supplied) or use the
Housing
to
make electrical connections. Inner globe is provided for clear
and colored globes.
Fixture can not be mounted upside
down in wet locations!
DO NOT USE FIXTURE WITHOUT OUTER GLOBE.
1.
Loosen
Housing Screws
and open
Housing
.
2.
Prepare back of
Housing
to use by knocking out
necessary mounting holes. Seal all gaps between ceiling
and fixture with weatherproof silicone sealant.
3.
Fixture may be wired through back conduit entrance or
side conduit entrance for surface mounting. Connect
wires as described in wiring section.
4.
Close
Housing.
Tighten screws and check
Housing
Gasket
seal. Seal all unused plugs with weatherproof
silicone sealant.
5.
Screw in required glass globe or permaglobe. Tighten
Outer Globe
until it makes full contact with
Globe
Gasket. OUTER GLOBE REQUIRED!
6.
Screw on optional wire or diecast
Guard
.
LIGHT
FIXTURE
(+)LINE
BLACK
(-)COMMON WHITE
GROUND
GROUND
Easy Installation & Product Help
Tech Help Line
Call our experts 888 RAB-1000
©2016 RAB LIGHTING Inc.
Northvale, New Jersey 07647 USA
rabweb.com
Visit our website for product info
Answered promptly sales@rabweb.com
US:
pat. D653,795; D651738;
CN:
ZL201130028359.7;
ZL201130028360.X;
TW:
pat. 101301369;
MX:
35699;
Pat.
pending; CA:
D RAB Lighting Inc;
