WPLED52 Series INSTALLATION INSTRUCTIONS
IMPORTANT
READ CAREFULLY BEFORE INSTALLING FIXTURE. RETAIN THESE INSTRUCTIONS FOR FUTURE REFERENCE
.
RAB fi xtures must be wired in accordance with the National Electrical Code and all applicable local codes. Proper
grounding is required for safety. THIS PRODUCT MUST BE INSTALLED IN ACCORDANCE WITH THE APPLICABLE
INSTALLATION CODE BY A PERSON FAMILIAR WITH THE CONSTRUCTION AND OPERATION OF THE PRODUCT
AND THE HAZARDS INVOLVED.
WARNING: Make certain power is OFF before installing or maintaining fi xture. No user serviceable
parts inside.
Thank you for buying RAB lighting fi xtures. Our goal is to design the best quality products to get the job done right. We’d like to hear your comments.
Call the Marketing Department at 888-RAB-1000, or email: marketing@rabweb.com
Note: These instructions do not cover all details or variations
in equipment nor do they provide for every possible situation
during installation, operation or maintenance.
MOUNTING TO A WALL
1. Orient box so that “TOP” is on top.
2. Secure
Wall Mounting Box
to a sturdy wall. Use
appropriate mounting hardware such as lag bolts
and anchors with washers suitable for the mounting
surface.
3. Feed supply wires through
Wall Mounting Box.
Check that
Gasket
is fully sealed.
4. Bring fi xture up to the
Wall Mounting Box
and slide
the stainless steel
Tether
from the fi xture into the
Key
Hole Slot
for hands free wiring.
5. Wire the fi xture using suitable wire connectors.
6. Place wired fi xture over the
Wall Mounting Box
and
tighten the
Top Screws
. Now tighten the
Lower
Screws
.
7. Tighten
Close Up Plugs
and apply weatherproof sili-
cone sealant to all unused conduit entry points. Also
use sealant between the wall and
Wall Mount Box.
4.57”
2.4”
1.09”
.79”
3.0”
Wall Feed
Conduit Feed
Hardware
(not supplied)
Wall Mount
Box
Top Screws
Lower
Screws
WPLED52
Standard (15 Deg)
WPLEDC52
Cutoff (7.5 Deg)
WPLEDFC52
Full Cutoff (0 Deg)
Close Up
Plugs (4)
Gasket
Tether
Key Hole
Slot
