background image

HP083 - Issue 1 - R.W. 08-01-07

   

GUARANTEE

This product is guaranteed for domestic use for a period of 12 months against faulty manufacture or materials. 
This guarantee does not affect the statutory rights of the consumer. If in the event of any problem occurring please 
contact our Helpline at the number above for advice. This product is not guaranteed for HIRE purpose.

Manufactured under licence by Hilka Pro Imports.

 1 ROEBUCK PLACE, ROEBUCK ROAD, CHESSINGTON, SURREY KT9 1EU

If faults cannot be remedied, contact the 

Helpline 

on 

020-83916767

Helpline@hilka.co.uk

Portable Power Station/Engine Starter

RAC-HP083

Environmental protection

 

Waste electrical products should not be disposed of with household waste.

 

Please recycle where facilities exist. Check with your local authority or retailer

 for 

recycling 

advice.

MAINTENANCE

Always inspect the tool before use to ensure the cables are in good condition and 
the clamps are clean and free from corrosion. Have them replaced if there is any damage. 
Keep clean by wiping with a dry cloth. Do not use solvents as a cleaning agent.

12V DC outlet socket
A built-in protective device will limit the power when the product overloads. In this case, 
disconnect the device that provoked the overload and wait for approximately five minutes 
before re-use.

WARNING: 

•  Do not use the output socket and engine starter at the same time.
•  The output can be as high as 13 volts after the product has been fully charged,   
 

consult your appliance handbook to ensure it is safe to operate.

•  Do not allow the battery to be completely discharged, i.e. below 11.2V, as the charger 
 

can not recover a deeply discharged battery.

Summary of Contents for HP083

Page 1: ...cycle where facilities exist Check with your local authority or retailer for recycling advice MAINTENANCE Always inspect the tool before use to ensure the cables are in good condition and the clamps are clean and free from corrosion Have them replaced if there is any damage Keep clean by wiping with a dry cloth Do not use solvents as a cleaning agent 12V DC outlet socket A built in protective devi...

Page 2: ...harged The product should be kept fully charged when not in use If kept in storage it must be recharged every 2 months The product is designed for use with 12V systems only Do not use engine starter for any purpose other than that is designed For best performance do not use more than one output at a time When using the 12V DC output socket ensure that the plug of the item you are to power has the ...

Page 3: ...ly recharge the battery every 2 months Do not allow battery to be completely depleted as this can damage the battery HOW TO CHARGE The internal battery should only be charged using the accessories supplied Two means of charging the internal battery are available The recommended method of charging is via the AC charger A Via 230V mains supply using the AC charger 1 Insert the jack plug of the AC ch...

Page 4: ...erminal and restore it to its storage position STORAGE MAINTENANCE Protect the product from direct sunlight and other heat sources as there is a risk of explosion of the internal battery Store at a temperature between 4ºC to 40ºC The technology used during the manufacture of the internal battery excludes any risk of electrolyte gel leakage from the inside of the battery You are nevertheless recomm...

Reviews: