background image

    

RC2200DB

 

 

 

 

 

2004 Radiocrafts AS 

RC2200DB ZigBee Demonstration Board Quick Start (rev. 0.2) 

Page 1 of 2 

 

RC2200DB ZigBee™ Demonstration Board Quick Start

 

 

 

 

 

 

 

Introduction 

The RC2200DB Demonstration Board shows a ZigBee™-ready home lighting profile. To 

make the demonstration a minimum of two (optionally three) boards are used: 

1.  Switch Load Controller (SLC) configured as network coordinator 

2.  Switch Remote Control (SRC) configured as network router 

3.  A second Switch Remote Control (SRC) configured as network router (optional) 

 

To monitor the ZigBee network communication a “packet sniffer” application could be installed 

on a PC. However, this is not required to do a simple demonstration. 

 

Summary of Contents for ZigBee RC2200DD

Page 1: ...ile To make the demonstration a minimum of two optionally three boards are used 1 Switch Load Controller SLC configured as network coordinator 2 Switch Remote Control SRC configured as network router 3 A second Switch Remote Control SRC configured as network router optional To monitor the ZigBee network communication a packet sniffer application could be installed on a PC However this is not requi...

Page 2: ...switch shall be bound to control one particular load controller lamp Push button number 5 BIND on the SRC in order to initiate the binding process Within 10 seconds push button number 5 BIND on the SLC The SRC will light up its green LED to indicate a successful binding Repeat 2 and 3 above for the second SRC 4 Make an automatic end device binding by using service discovery As an alternative to ma...

Page 3: ...ile To make the demonstration a minimum of two optionally three boards are used 1 Switch Load Controller SLC configured as network coordinator 2 Switch Remote Control SRC configured as network router 3 A second Switch Remote Control SRC configured as network router optional To monitor the ZigBee network communication a packet sniffer application could be installed on a PC However this is not requi...

Page 4: ...switch shall be bound to control one particular load controller lamp Push button number 5 BIND on the SRC in order to initiate the binding process Within 10 seconds push button number 5 BIND on the SLC The SRC will light up its green LED to indicate a successful binding Repeat 2 and 3 above for the second SRC 4 Make an automatic end device binding by using service discovery As an alternative to ma...

Reviews: