WCM-020 Instruction Manual
For programming information:
Wired system Programming Guide
For general overview:
What is the WCM-020?
The WCM-020 wired keypad is a two button keypad for use with the
wired system. It will transmit Scene 1 and Off before any custom
programming is added.
WCMs require a RAK-LINK to operate as part of the system. WCMs
(as part of the wired network generally) can be wired in two ways:
“Daisy Chain” configuration -
A single run of keypads runs from the
RAK-LINK and to an end point. It is still usually advisable to run a
return leg back to
the RAK-LINK as a spare.
“STAR” configuration -
Cables are all run back to a central point: a RAK-STAR usually
located with the RAK-LINK. Each cable can be from a single keypad or a leg of keypads.
Installation Note:
The WCM comes in two sections “Front” and “Back” they are referred to as such in the following
installation guide. The “Back” section is just a connection board for the CAT5/6 cable. The “Front”
section contains all memory and programming.
WCM-020
Manual Version 2.0.2
