background image

QUICK START SETUP GUIDE- Demounting

   

 

1.   The Centering Cone must make contact with the Hub 

Hole Edge. 

2. You 

MUST

 use the Turntable Spacer when the Hub 

Hole of the Rim requires use of either of the Large Cen-

tering Cones.

3.  Use of the Large Centering Cone without the Spacer 

will prevent proper wheel mounting.

Setting the Bead Breaker Roller

and “Target Lock” Distance.

1.  Set the distance from the Rim edge to the Bead 

Breaker Roller to 1/8’.

2.  Once this distance is set. DO NOT move the

Turntable.  When you press the “Target Lock” Button for 

the Bead Hook / Tab Arm, the Hook/Tab Arm will extend 

and stop the same distance from the Rim that was set 

with the Bead Breaker Roller.

3.  ALWAYS liberally lube both Upper and Lower Beads, 

then Hook Upper Bead as Shown.

REFER TO THE COMPLETE SAFETY, INSTALLATION AND OPERATION MANUAL IF YOU ARE UNSURE OF ANY 

TIRE MOUNTING OR DEMOUNTING PROCEDURES OR HAVE NOT USED THIS STYLE OF TIRE CHANGER.

IMPORTANT! FOLLOW THIS SET UP GUIDE PRIOR

TO USING THE MACHINE OR DAMAGE TO THE

TIRE CHANGER OR RIM & TIRE MAY OCCUR!

Reviews: