E100/E125 (V16+), E150 (V6+),
E175 (V19+), ESPARK ELECTRIC SCOOTER
BATTERY INSTALLATION INSTRUCTIONS
WARNING
Do not use non-Razor products with your Razor electric
scooter. The scooter has been built to certain Razor
design specifications.Certain aftermarket parts may or
may not be compatible.
As with all consumer electronics, use of compatible
batteries and chargers is strongly recommended. Failure
to do so may pose a fire hazard.
Examine the battery, charger and their connectors for
excessive wear or damage each time you charge the
battery. If damage or excessive wear is detected, do not
use the charger or the vehicle until you have replaced
the worn or damaged part.
Battery connectors may contain lead and lead
compounds.
Wash your hands after handling.
Need Help?
Visit our website at
www.razor.com
or call toll-free at
866-467-2967
Monday - Friday 8:00am - 5:00pm Pacific Time.
1
Tools Required:
(
Not included
)
A. Phillips head screwdriver
B. 4mm Allen wrench
C. 8mm open wrench
CAUTION:
To avoid potential shock or other injury, turn power switch OFF and discon-
nect charger before removing or installing the batteries. Failure to follow these steps in the
correct order may cause irreparable damage.
Figure 1
Figure 2
Step 1
Using a Phillips head screwdriver, remove the four
screws in the front of the deck. Using a Phillips
head screwdriver and 8mm open wrench, remove
the two screws and locknuts in the back of the
deck. Using a 4mm Allen wrench remove the two
hex bolts. Remove deck plate.
Note:
If you are having difficulty removing the
screws, use pliers to twist the screw out from the
bottom.
Using a Phillips head screwdriver, remove the
screws on the battery bracket and remove
bracket.
Step 2
Phillips head screwdriver
4mm Allen wrench
Phillips head screwdriver on top,
8mm open wrench on bottom
