Razor POWER A 2 Quick Start Manual Download

Page: 1 / 4

Need Help?

Visit our website at

www.razor.com

or call toll-free at

866-467-2967

Monday - Friday 8:00am - 5:00pm Pacific Time.

WARNING

Step 1

Step 2

Required Tools: (Not included)

A. Phillips screwdriver

B. Small Flat screwdriver

C. Long needle nose pliers

D. 3 mm Allen wrench

E. 5 mm Allen wrench

CAUTION:

To avoid potential shock or other injury, turn power switch OFF and disconnect

charger before conducting any assembly or maintenance procedures. Failure to follow these
steps in the correct order may cause irreparable damage.

Using a Phillips screwdriver, remove the screw located at

the very front of the deck and pull the deck cover off from

the deck.

Disconnect the throttle cable from the controller.

POWER A2

QUICK RELEASE / STEM

REPLACEMENT PROCEDURES

PART # W13113202032

Summary of Contents for POWER A 2

Page 1: ...ench CAUTION To avoid potential shock or other injury turn power switch OFF and disconnect charger before conducting any assembly or maintenance procedures Failure to follow these steps in the correct...

Page 2: ...he grommet inside the opening of the deck Using a smal flat screwdriver remove the C ring from the folding mechanism pin Slide the pin out from the frame Unfold the unit Using a pair of long needle no...

Page 3: ...00pm Pacific Time 3 Step 7 Step 8 Unscrew and remove the knob Slide down the plastic block of the folding mechanism Using a 5 mm Allen wrench loosen the bolt from the collar clamp and remove the stem...

Page 4: ...866 467 2967 Monday Friday 8 00am 5 00pm Pacific Time 4 Step 13 Reverse the steps ATTENTION Charge battery 8 hours before using Using a 3 mm Allen wrench loosen the screw from the quick release Slide...