Razor W15155049003 Battery Replacement Procedure Download

Page: 1 / 5

Need Help?

Visit our website at

www.razor.com

or call toll-free at

866-467-2967

Monday - Friday 8:00am - 5:00pm Pacific Time.

WARNING

Step 1

Step 2

Required Tools: (Not included)

A. Phillips screwdriver

B. 4 mm Allen wrench

CAUTION:

To avoid potential shock or other injury, turn power switch OFF and disconnect

charger before conducting any assembly or maintenance procedures. Failure to follow these
steps in the correct order may cause irreparable damage.

Using a Phillips screwdriver, remove nine (9) screws from

the bottom of the deck.

Using a 4 mm Allen wrench, remove two (2) hex screws.

One on each side of the deck.

POWER A2

BATTERY REPLACEMENT PROCEDURES

PART # W15155049003

Summary of Contents for W15155049003

Page 2: ...cover from the unit Locate and disconnect the throttle wire from the controller Using a 4 mm Allen wrench remove two 2 hex screws and pull the bracket out of the frame Remove the grommet from the metal bracket Push the throttle wire inside the opening Remove the controller cover to access the wires Remove the grommet at the back of the tray Step 5 Step 6 ...

Page 3: ...Step 8 Disconnect the three 3 wires from the back of the unit Place battery on tray with label facing down and connect to controller Push down on the power switch and slide the battery tray out of the deck Line up the wires and slide battery tray back inside the frame Reposition the grommet at the back of the tray Step 9 Step 10 ...

Page 4: ...t all connectors NOTE There is one connector that is empty Reconnect throttle to controller and place the grommet back into the bracket Place bracket back on the unit and pull the throttle wire through the opening on the bracket Secure the bracket to frame Place the plastic cover back onto the unit Step 11 Step 13 Step 12 Step 14 ...

Page 5: ...e at www razor com or call toll free at 866 467 2967 Monday Friday 8 00am 5 00pm Pacific Time 5 Reposition controller cover and secure with screws Reverse the steps ATTENTION Charge battery 10 hours before using Step 15 Step 16 ...