RBH blueLINE
TM
Readers Installation Manual
Readers in the blueLINE
TM
series are capable of using
DESFire (EV1 & EV2)
and
Mifare
credentials for the highest of security standards and
up to 128
bit credentials are supported
. Communication to controllers can be using
standard Wiegand or OSDP version 1 & 2
for increased security where
maximum integrity and tamper conditions are required. All blueLINE
TM
readers use
UHSC via NFC or Bluetooth
and supports both
Android and IOS
operating system
devices for build revision version 17-1.0.8g and up.
I.
BlueLINE
TM
Readers Models and Mounting
Surface Mounting using 2 provided
anchoring screws:
II.
Cabling and Communication
Wiring is in accordance with the National Electrical Code, ANSI/NFPA 70
Wiegand
OSDP
500’ (152m) max, 18
-22 AWG, 6-7 conductor
shielded cable
RS485: 2,000’ (610m) max, 20
-22 AWG, 1 twisted stranded shielded
pair cable
Wire Color
Function
Wire Color
Function
Red:
9
–
12 VDC
Red:
9
–
12 VDC
Black:
Ground
Black:
Ground
Brown:
RS485+
Brown:
RS485+
Orange:
RS485-
Orange:
RS485-
Green:
WD0
Default Baud rate: 9600 bps
White:
WD1
Default Address: 1
Blue:
LED
Default Secure Channel Key:
Yellow:
Buzzer
SCBK_D = 0x303132333435363738393A3B3C3D3E3
III.
Power Supply
DC power for this reader is generally supplied from terminals of the Wiegand reader port on the system’s panel and panel is b
attery backed up. If
this is not possible, use an independent power supply. Power should be nominal 9 - 15 volts DC @ 120ma regulated output. If the power supply is
independent from the panel’s reader port, the reader’s black wire must be connected to both the power supply’s Negative terminal and the panel’s
Ground terminal.
IV.
Operation
1.
When the reader is first powered on it will beep twice and the LED will turn blue.
2.
When presented with a supported access credential the reader will perform the following operations:
LED
Buzzer
Access Granted
Turn Green for unlock time
Beeps Once
Access Denied
Flashes Red and Green
Beeps Twice
Standby (Card Swipe not needed)
Stays Blue
No Sound
Model
Single Gang Mount
Mullion Mount
Firmware
RBH-N86-D
X
10-XXXX
RBH-N86-DNB
X
11-XXXX
RBH-M45-D
X
10-XXXX
RBH-M45-DNB
X
11-XXXX
RBH-NK86-D
X
10-XXXX
RBH-NK86-DNB
X
11-XXXX
*** D=Desfire(EV1 & EV2) DNB=Desfire(EV1 & EV2), NFC and Bluetooth ***
