background image

EN

EN

FCC Information

1

FCC Information

This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two
conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any
interference received, including interference that
may cause undesired operation.
In accordance with FCC requirements, changes or
modifications not expressly approved by Thomson
Inc. could void the user’s authority to operate this
product.
This device generates and uses radio frequency
(RF) energy, and if not installed and used properly,
this equipment may cause interference to radio
and television reception.
If this equipment does cause interference to radio
or television reception (which you can determine
by unplugging the unit), try to correct the
interference by one or more of the following
measures:
• Re-orient the receiving antenna (that is, the
antenna for the radio or television that is
“receiving” the interference).
• Move the unit away from the equipment that is
receiving interference.
• Plug the unit into a different wall outlet so that
the unit and the equipment receiving interference
are on different branch circuits.
If these measures do not eliminate the
interference, please consult your dealer or an
experienced radio/television technician for
additional suggestions. Also, the Federal
Communications Commission has prepared a
helpful booklet, “How To Identify and Resolve
Radio TV Interference Problems.” This booklet is
available from the U.S. Government Printing
Office, Washington, DC 20402. Please specify stock
number 004-000-00345-4 when ordering copies.

CAUTION:

 FOR CONTINUED PROTECTION

AGAINST RISK OF FIRE, REPLACE ONLY WITH
SAME TYPE FUSE.

For Your Safety

The AC power plug is polarized
(one blade is wider than the
other) and only fits into AC
power outlets one way.  If the
plug will not go into the outlet
completely, turn the plug over
and try to insert it the other
way.  If it still does not fit, contact a qualified
electrician to change the outlet, or use a different
one.  Do not attempt to bypass this safety feature.

CAUTION: TO PREVENT ELECTRIC

SHOCK, MATCH WIDE BLADE OF

PLUG TO WIDE SLOT, FULLY INSERT.

Technical Specification

Product: Clock Radio with CD player
Brand: RCA
Model: RP4803

Electrical Consumption

Power Supply: 120V~60Hz
Power Consumption: 11 Watts

IMPORTER
Comercializadora Thomson de México, S.A. de
C.V.
Álvaro Obregón No. 151. Piso 13.
Col. Roma. Delegación Cuauhtémoc
C.P. 06700. México, D.F.
Telefono: 52-55-11-020360
RFC: CTM-980723-KS5

For Your Records

In the event that service should be required, you
may need the model number.  In the space below,
record the date and place of purchase:

Date of Purchase:
Place of Purchase:

Service Information

This product should be serviced only by those
specially trained in appropriate servicing
techniques.  For instructions on how to obtain
service, refer to the warranty included in this
Guide.

 

      

 

 

 

 

 

RP4803 EN

6/9/05, 11:37 AM

2-3

Summary of Contents for RP4803







Reviews: