DESCRIPTION
The compact PSDR power supplies are industrial input voltage supplies with
primary switched-mode regulator technology. They feature low output ripple
and adjusted output voltage from 22.5 to 28.5 VDC. The output is electronically
protected against overloads and short circuits.
The modules snap onto standard 35 mm flat DIN rails and use removable
terminal blocks for easy wiring.
SPECIFICATIONS
1.
POWER REQUIREMENTS
:
Nominal Input Voltage: 100 to 240 VAC
Input Voltage Range: 85 to 264 VAC or 90 to 350 VDC
Current Consumption at nominal input voltage:
PSDR0100: 0.5 A to 0.2 A @ 100 to 240 VAC, 0.4 to 0.1 A @ 90 to 350 VDC
PSDR0200: 0.82 A to 0.33 A @ 100 to 240 VAC, 0.65 to 0.19 A @ 90 to 350 VDC
PSDR0400: 1.8 A to 0.7 A @ 100 to 240 VAC, 1.3 to 0.4 A @ 90 to 350 VDC
2.
FREQUENCY
: 50 to 60 Hz
3.
INPUT RECOMMENDED BACKUP FUSE
:
Power Circuit Breaker: 6 A or 10 A
Characteristic: B (EN 60898)
4.
SURGE VOLTAGE PROTECTION
: Varistor
5.
POWER OUTPUT
: Nominal value of 24 VDC ±1%. Adjustable from 22.5
to 28.5 VDC via potentiometer
6.
EFFICIENCY AT 230 VAC AND NOMINAL VALUES
: > 80 %
7.
ENVIRONMENTAL CONDITIONS
:
Operating Temperature Range: -25 to 60°C
Storage Temperature: -40 to 85°C
Humidity, no moisture condensation: 95 % at 25°C
Vibration in acc. with IEC 68-2-6: < 15 Hz, amplitude ±2.5 mm;
15 Hz - 150 Hz, 2.3 g
Shock in all directions acc. with IEC 68-2-27: 30 g
Contamination in acc. with EN 50178: Degree of pollution 2
8.
STANDARDS AND CERTIFICATIONS
:
EN 55011 corresponds to CISPR11 / EN 55022 corresponds to CISPR22
EN 61000 corresponds to IEC 1000
9.
ISOLATION VOLTAGE
: Input/Output 3 kVAC
10.
INSTALLATION POSITION
: On horizontal mounting rail according to
EN 50022-35
11.
CONNECTIONS
: 24 to 14 AWG max. Torque 4.5 to 5.3 inch-lbs
(0.5-0.6 Nm).
12.
MOUNTING
: Standard DIN rail top hat (T) profile rail according to
EN50022 - 35 X 7.5 and 35 X 15. Can be mounted in rows with vertical
Spacing > 5 cm or horizontally with no space.
13.
CONSTRUCTION
: Case body is black, high impact plastic. IP20 touch
safe. Protection Class II.
14.
MTBF
(Mean Time Between Failure): >500000 h in acc. with IEC 1709 (SN
29500)
15.
WEIGHT
:
PSDR0100: 7.4 oz. (210 g)
PSDR0200: 8.8 oz. (250 g)
PSDR0400: 14.1 oz. (400 g)
MODEL PSDR - 24 V POWER SUPPLIES @ 1, 2, OR 4 A
DIMENSIONS In inches (mm)
Bulletin No. PSDR-A
Drawing No. LP0604
Released 8/07
Tel +1 (717) 767-6511
Fax +1 (717) 764-0839
www.redlion.net
Industrial regulating devices
Electrical Safety (of information
technology equipment)
EN 50178 / VDE 0160
Limitation of output power
Safe isolation
NEC Class 2
VDE 0100-410
Protection against electric shock
DIN VDE 0106-101
1)
Criterion A:
Normal operating behavior within the defined limits.
2)
Criterion B:
Temporary impairment to operational behavior, that is
corrected by the device itself.
3)
Symmetrical:
Conductor to conductor.
4)
Asymmetrical: Conductor to ground.
5)
Class B:
Area of application industry and residential.
EN 61000-4-11
2)
I/O/S: Level 3
Frequency/U
o
: 0.15-80 MHz / 10 V
Discharge of static electricity (ESD)
In conformance with EMC guideline 89/336/EEC
and low-voltage directive 73/23/EEC
Electromagnetic HF field
EN 55011 (EN 55022) Class B
5)
EN 55011 (EN 55022) Class B
5)
ENV 50204
Simulation mobile phones
Emitted radio interference
Radio interference voltage
Input: see mains buffering
> 20 ms
Voltage dips
EN 61000-4-6
1)
Conducted disturbance
EN 61000-4-5
2)
Surge voltage capacities (Surge)
EN 61000-4-4
2)
Fast transients (Burst)
EN 61000-4-3
1)
Housing > Level 3
Contact discharge: 8 kV
Discharge in air: 8 kV
EN 61000-4-2
2)
Frequency: 900 MHz, 1800 MHz
Field intensity: 20 V/m
Noise emission according to EN 50081-2
EMC (Electromagnetic compatibility)
Immunity in accordance with EN 61000-6-2
Input: 4 kV (Level 4)
4)
Output: 2 kV (Level 3)
4)
Signal: 1 kV (Level 2)
4)
Housing Level 3
Frequency/Field intensity: 80-1000
MHz / 10 V/m
Input: 4 kV
4)
/ 2 kV
4)
(Level 4)
Output: 0.5 kV
4)
/ 0.5 kV
3)
(Level 1)
Signal: 0.5 kV
4)
(Level 1)
EN 60950 / VDE 0805
MODEL
C
PSDR0100
PSDR0200 1.77 (45)
PSDR0400 2.66 (67.5)
0.87 (22.5)
UL Recognized UL 60 950
UL 508 listed
C
US
UL
R
LISTED
Electronic equipment for use in
electrical power installations
(surge voltage category III)