P.O Box 578 Casino, NSW, 2470 Australia
Phone: International ++614 2902 9083
Australia (04) 2902 9083
Website:
http://rcs-rc.com
E mail:
Info@rcs-rc.com
TX-20+
Digital Proportional R/C
TABLE OF CONTENTS
PROVIDED IN INSTRUCTIONS.
Page # 1 Introduction.
Page # 2 Preparing the TX-20+. Binding.
Page # 3 Calibrating the system.
Page # 4 Using TX-20+ with a LOW off ESC.
Specific instructions for operating an RCS ESC
are found with the supplied ESC
Eg Speed & Direction control.
Using Sound Trigger functions.
Programming the ESC
Trouble shooting etc
PLEASE NOTE. PDF WIRING INSTRUCTIONS ARE HERE:
http://www.rcs-rc.com/pages/instructions
Thank you for purchasing this Microprocessor based
E
lectronic
S
peed
C
ontrol
(ESC)
R/C system.
THE TX-20+ IS ONLY FOR USE WITH RCS OMEGA-3 ECS’s THAT USE OPERATING
PROGRAM RCS-v1 or ALPHA-3 ESC’s.
THIS IS BECAUSE OF THE WAY THE ESC’s OPERATE. A SPRING LOADED SWITCH
CHANGES DIRECTION, JUST LIKE THE SPRING LOADED ELEVATOR CONTROL ON A
STICK RADIO.
THE TX-20+ IS NOT SUITABLE FOR USE WITH CENTRE OFF BATTERY R/C OR LIVE STEAM LOCOS.
INSTRUCTION MANUAL
THESE INSTRUCTIONS REFER SPECIFICALLY TO THE TX-20+ HANDPIECE.
They should be read in conjunction with the RCS ESC you are using.
SWITCH FOR DIRECTION SETTING.
300º KNOB CONTROL OF SPEED.
NOT SUITABLE FOR LIVE STEAM
.
REMOVE REAR OF TX-20+
INSERT THE 9 VOLT BATTERY.
.
THE TX-20+ IS GUARANTEED FOR ONE YEAR.
You will supply a locomotive or trail car, the 14 – 20 volt traction batteries (depending on ESC), a fuse,
ON-OFF switch and wires where necessary, to connect the ESC to the battery and motor(s).
Where soldering is necessary, we recommend a low wattage soldering iron and resin core solder.
TO AVOID CONFUSION WITH OTHER OPERATORS, WE SUGGEST YOU MARK THE TX TO
SHOW WHICH LOCO IT IS OPERATING.
CAUTION
DO NOT ATTEMPT TO ALTER THE TUNING OF THE RADIO EQUIPMENT.
DO NOT USE RADIO CONTROL EQUIPMENT IN THUNDERSTORMS.
CHILDREN UNDER 12: ADULT SUPERVISION RECOMMENDED DURING USE.
