STEP 1 Open the Bottom Cover
Release the lock.
Release the lock using thumb, check if the lock stays in released position.
Lock is released.
Release one side.
Slightly release one side of the bottom cover, then another side. Remove the cover.
Lock is locked.
Release another side.
Release the bottom cover.
Good grip is very helpful - dry hands will
make the operation way easier.
Make sure you say
„Aloha“
:)
Practice – soon, you will be able to do
the trick in a second.
STEP 2 Release the Base panel
How it works?
To perfom this step, both side-locks
of Auto-Lock system should be
released prior to pulling the Base
Panel out of the Top Cover.
There are two tricks how to do it:
A. Left-Right Way
Press the lock on one side of the box
and slightly pull out the Base Panel so
the lock does not lock again and stays
unlocked even when you release your
hand. Press the lock on the another
side and pull the Base panel out
completely.
B. „Aloha“ :) Way
You can do the same in one step using
only one hand. This is very useful
when outdoor, on the roof, ladder etc.
Grip the base panel with middle three
fingers of your hand. While pushing
the thumb and pinky to release both
side locks, pull out the Base Panel.
Release another side-lock.
Release one side-lock.
Pull out the Base Panel.
Grip the Base Panel.
Push.
Pull out the Base Panel.
1 How To Open StationBox® Mikro
Quick Installation Guide
StationBox® Mikro
www.rfelements.com
®
