background image

 

 

Quick Guide

 

-DC9250DP 

 

H92P 

                 

 

 
 

Connect to micro USB port of OTG device 

 
 

 

 

 

 

 

3

 

 

 

*

 

Before you use scanner, please switch to "C" for battery charge 

for 3~4 hours. 

*

 

Under “C mode”, you can raise/lower soft-keyboard easily.(For 

USB HID only)

4

 

 

 

H92P Scan Holder is with Li-Ion battery inside. When in charging, 
please  use  the  original  USB  power  adaptor  of  OTG  device 

(recommended). Through it, it charges both OTG device and H92P 
internal battery at the same time. When in low battery (Red LED 
flashing), please charge it immediately. 

 

LED Indicator Information 

Green LED OFF 

Full charged (Charge mode) 

Green LED ON 

Charging (Charge mode) 

Red LED Flashing 

Low battery (Operation mode)

Attention: Under “Operation mode” please do not charging, 
otherwise the OTG device's battery will be charging back to H92P’s 
battery. 

 

 

5

 

 

 

 

The touch sensor area is around the central area. (For both sides). 
Please check the above drawing for your reference. 

 

 

Installation 

Before using scanner, please make sure that the OTG device is fully 
charged. 

1.

 

Under USB HID interface 
** When plugged into OTG device, it will be recognized and begin 

to scan the barcode.  

2.

 

Under USB Serial interface 
** Please install PL-2303 driver into your OTG device first. PL-2303 
driver can be downloaded from Google Play 
** Connect scanner to your OTG device, then, you can know which 
serial port scanner connects to.  
** The data you scan will be sent to serial port and your APP can 
get the data from serial port directly.

 

 

Suction Cup

Micro USB 

cable (OTG) 

Li- Ion 

Battery 

Trigger Area

O = Operation mode

C = Charge mode

LED Indicator

LED Indicator

Charge port

H92P 

Mini 

scanner 

PU Glue

(Can be used 

repeatedly) 

Reviews: