background image

 

  

 

RLH Industries, Inc. • Tel. 866-DO-FIBER • Fax 714 532-1885 • www.fiberopticlink.com

 

Page 1

Ethernet Over Fiber
4RU Plug-in Card

10/100/1000M ETHERNET

Introduction

The RLH  10/100/1000  Ethernet 4RU Interface Card converts  a 
copper  10Base-T  or  100/1000Base-TX  to  a 1000Base-SX/LX 
fiber  optic  transmission  signal  of  either  multimode  or  single-
mode.  The   cards  transmit  the  data  signals  over  fiber  optic 
cable  which  allow for  network  extension  over  long  distances, 
and  provide   electrical  isolation  between  both  ends  of  the 
network.

The Ethernet over fiber card  may be used as a  system, with a 
card  at each  end,  or  the  fiber optic  cable may  be  connected 
directly to any 1000Base-SX/LX compatible device.

This   hardened,  rugged  system   is   covered  by  our 

Exclusive 

Unconditional Lifetime Warranty.

Key Features

Ideal for critical, high voltage, remote or un-manned
locations that must remain operating 24/7/365

Compatibility with IEEE 802.3/AB

RJ45 UTP port with 10/100/1000 auto-negotiation

Extends network span up to 1.2 miles (2km) on multimode and 
up to 74 miles (120km) on single-mode fiber

Convenient LED status indicators

Link alarm function for status monitoring

Dual and Single (bi-directional) fiber models available

Environmentally hardened to operate in -40°F to +158°F
(-40°C to +70°C) environments

Standard RLH 4RU form factor

Covered by our 

Exclusive Unconditional Lifetime Warranty

2012D-1105

Specifications subject to change without notice.

RLH 10/100/1000 Ethernet over Fiber Card

&-) )

The leader in
rugged fiber optic 
technology.

 

Unconditional

Lifetime Warranty

USER GUIDE

RLH Industries, Inc.

Contents

_________________________

Introduction 

 

1

_________________

General Safety Practices

 

2

____________

Special Handling Requirements

 

2

___________________________

Acronyms 

 

3

_________________________

Applications 

 

3

__________________________

Installation 

 

4

_______________________

LED Indicators 

 

5

_____________________

DIP Switch Settings

 

5

__________________________

Link Alarm 

 

6

__________________

Ordering Information 

 

6

___________________

General Specifications

 

7

_______________________

Troubleshooting

 

8

___________________________

Warranty 

 

8

_____________________

Technical Support 

 

8

Summary of Contents for 10/100/1000 Ethernet 4RU Interface Card











Reviews: