NEUTRON-SF
Soft Close Quick Release
Toilet Seat
FITTING INSTRUCTIONS
Please read carefully before attempting to fit the seat & refer to the ‘does it fit’
diagram below to ensure it’s suitable for your toilet.
Please make sure the warnings and after-care instructions are made available for
the end user to read.
Does it fit?
general seat dimension
max/min fixing adjustment
Please can you
measure before
opening the pack
Top Fix Installation
2
3
Add the cover cap and click seat in place.
5
EN
B
C
Using the anchor template provided, place over the two pins, making
sure the template is parallel to the back of the pan and the pins are
facing toward the bowl.
C
C
If fitting on alternative pan, please proceed to instructions B
Insert screw through hole 4 (marked on the plate) of the hinge
anchor and into the top fix inserts, fixing semi-tight to the pan, to
allow for adjustment.
A
445mm
376mm
460mm (max)
400mm (min)
54mm (min)
172mm (max)
4
Once the template is in place and correctly positioned (430mm +/- 3
from the front of the pan to centre line of the template), hold the
hinges securely and tighten the fixing screws with a screw driver.
Remove the template.
Check there is a distance of 430mm (+/-3)
from the front of the pan to the centre line
of the template. Adjust if necessary.
Template and
back edge of pan
parallel
430mm
E
1
Push top fix inserts into toilet pan holes.
If difficult to push in, lubricate the rubber insert with water.
D
Note - alternative nuts and washers are supplied if you wish to secure the
seat from underneath the deck of the toilet pan. If so dispose of the black
top fix inserts and tighten with the securing key supplied.
Instructions A - Fitting on Minerva Pan
Cover Plate
Fixing Screw
Hinge Anchor
Top Fix Insert
A
E
B
D
Anchor Template
C
