background image

OWNER’S MANUAL

ROUSSEAU COMPANY

Miter Saw Super Stand

Model SS2875

IMPORTANT

Read all safety guidelines and all

instructions before operating.

ROUSSEAU COMPANY

1712 13th Street - Clarkston, WA  99403

Phone:  1-(509)-758-3954
              1-(800)-635-3416

      Fax: 1-(509)-758-4991

Summary of Contents for SS2875

Page 1: ...COMPANY Miter Saw Super Stand Model SS2875 IMPORTANT Read all safety guidelines and all instructions before operating ROUSSEAU COMPANY 1712 13th Street Clarkston WA 99403 Phone 1 509 758 3954 1 800 635 3416 Fax 1 509 758 4991 ...

Page 2: ...serious injury or death and or damage to mitersaw and or stand if equipment is not used properly Please read the following instructions carefully Always operate on flat level surface with casters locked Failure to do so could result in tipping or rolling table which could cause kickback and or loss of fingers Be sure saw is bolted in securely Failure to do so could result in injury to self or saw ...

Page 3: ...T 1 SS3800 Stop System optional 2a top shelf b bottom shelf 3a left side b right side 4 3 locking casters 5 10 tape measure 6 hardware 16 nuts 16 bolts NOTE WHEN STAND IS FULLY ASSEMBLED SLOTS ON WINGS ARE TO THE REAR STEP 1 Fasten side frames to bottom shelf using bolts nuts provided Finger tighten STEP 2 Measure base height of saw STEP 3 Using tape measure straight edge set top shelf below wings...

Page 4: ...ximum support area and center from side to side STEP 8 Mark sites for drilling STEP 9 Remove saw from stand Drill holes in top using slightly oversized bit STEP 10 Secure saw to stand with bolts nuts and washers you provide STEP 11 Adjust wing height as needed to bring level with mitersaw base This is the only adjustment for wing height NOTE Do not tighten bolts at bottom of wing supports Wing sup...

Reviews: