Roverpet 44PR Assembly Instructions Download

Page: 1 / 3

Roverpet

20 Kiji Dava Circle Prescott, Arizona 86301

800-658-5925

rover@roverpet.com

Page 1 of 3

Roverpet #44PR

– 4’ x 4’ Puppy Rail Assembly Instructions

Inventory List for The Roverpet #44PR Puppy Rail System:

(2)

#PR48LB

48” Long Support Bar

(2) #48CB

48” Long Crossbar and

(4)

2”, 3”, 4”, 5”, 6” or 8” high legs (depending on style of Roverpet Puppy Rail System ordered)

Assembly Procedure

Special Notes:

If the Roverpet 4

’x4’ whelping box consists of a door panel, it needs to be configured with the door located on

the right to allow door hinge clearance.

Assembly of the Roverpet Puppy Rail System needs to be done outside of your existing Roverpet whelping box, than installed

into the whelping box once fully assembled.

1.) Unpack contents of shipping carton and compare to inventory list above.
2.) Install all

(4)

legs of the Roverpet Puppy Rail System into the 4 small leg hole locations on both #PR48LB.

Summary of Contents for 44PR

Page 1: ...ordered Assembly Procedure Special Notes If the Roverpet 4 x4 whelping box consists of a door panel it needs to be configured with the door located on the right to allow door hinge clearance Assembly...

Page 2: ...f the rails into your Roverpet whelping box Line up the PR48LB connecting ends with the 2nd vertical bars of the whelping box panels Note Make sure the PR48LB connecting end will not be installed on a...

Page 3: ...ystem down until all four legs are resting on the Roverpet whelping box floor Note Pig Rails can reduce the risk of possible suffocation Note Puppies should be watched at all times when small Congratu...