Caution:
The O-Pen™ was designed for use with clear tap water of unknown safety. It
may be used with fresh surface waters or collected rainwater, however it is quite
important that you make sure that water is clear.
DO NOT USE WITH CLOUDY WATER.
Examine the water carefully. If there is any cloudiness present, this is an indicator of
very high bacterial levels. While ozone is highly effective at killing bacteria, the O-
Pen™ may not generate enough ozone to kill very high levels of bacteria. Operate it
repeatedly until there is a strong smell of ozone. It is not possible to “over-ozonate”
water, however, you can under-dose it. If you cannot smell the ozone, it is probably
being used up by whatever is in the water. You may need to operate it many times to
be sure you can smell the ozone.
If, even after several uses of the O-Pen™, you cannot
smell the ozone, you should not consume the water.
Be Aware:
Infectious microbes can be encountered in many ways. Some other ways that
infectious diseases can be spread are through:
Foods washed in unsafe water
Contact with infected people, animals or objects
Unintentional water consumption, such as when brushing teeth, showering
or swimming.
Opportunities for infection are abundant and virtually everywhere so it is important to
realize that
use of a Roving Blue® O-Pen™ device does not guarantee that the user will
avoid illness
. To avoid microbial infection, one must take a wide range of precautions. Use
of a Roving Blue® O-Pen™ is an important precaution, but not the only precaution
that one should take.
Ongoing Care & Cleaning:
When not in use, the O-Pen™ should be charged and kept in its box. It should not be
exposed to temperatures above 140°F/60°C or below -4°F/-20°C. Store with the clear
dust cover in place. To clean the unit, wash it with a soft cloth and mild soap
solution. Rinse and shake dry and lay out to dry completely. Replace cap and store.
Periodic Maintenance:
Water often contains minerals such as calcium carbonate. Like a coffee-maker, these
minerals will slowly accumulate on the electrodes, and will cause the electrolysis
process to slow down. When the production of ozone appears weak, you may clean the
electrodes as follows:
1. Prepare a solution of tap water and regular kitchen vinegar at a ratio of 5 parts water
to 1 part vinegar.
2. Dip the ozone electrode into this solution for 10 minutes. Do NOT apply power.
3.
Stir a few times and remove from solution. Rinse the tip in cool tap water. After
cleaning the electrodes, normal production on will resume.
Roving Blue® O-Pen™
Operations Manual
rev.5
READ, FOLLOW AND SAVE THESE INSTRUCTIONS. THERE ARE NO USER-SERVICEBLE PARTS.
EXPOSING PARTS IN THE PEN WILL VOID YOUR WARRANTY.
INTERNAL PARTS SHOULD
NOT BE EXPOSED OR TAMPERED WITH.
DO NOT USE IN ANY OTHER MANNER THAN AS
DESCRIBED IN THIS MANUAL.
Roving Blue's® O-Pen™ technology is patent-pending. Roving Blue® is a registered
trademark of Roving Blue, Inc. O-Pen(TM) is a trademark of Roving Blue, Inc.
Introduction:
This user guide is written to assist in the operation and maintenance of your unit.
Please read this manual carefully and in its entirety before operating.
Failure to follow these instructions could result in personal injury, damage to the
equipment or reduced product performance. In our ongoing effort to improve reliability
and operating efficiency, Roving Blue®, Inc. may find it necessary to make changes to its
products. The information contained in this guide may not conform in every respect to
earlier versions. If you have any questions, please contact the Roving Blue® service
department:
Email: service@rovingblue.com
Roving Blue®, Inc.
5220 St. Patricks Road
Lena, Wisconsin USA 54139
Website: www.RovingBlue.com
Tel: (920) 621-2163
Intended Use: The O-Pen™ is designed to ensure safe drinking water from taps or other
clear water sources such as rainwater or clear streams. It does this by infusing the
water with high levels of ozone. Ozone is the most powerful oxidizer available that can
be safely used in water treatment.* Water that is visibly clouded with dirt, silt or algae
should be allowed to settle and/or should be pre-filtered. Also, water containing
tannins (a “tea” coloring) will be rendered safe to drink; however, the tea color may not
be removed.Don't forget to register your product. Go online to www.rovingblue.com/
warranty, or call with the following information: Name, address, serial number of Pen.
(Silver Pen, number is on a label inside the box lid, on the Tactical Black, the number is
engraved under the pen clip.) Date of Purchase.
*Water Quality Association , “Ozone for POU, POE and Small Water System Water Treatment Applications,” Lisle, IL 1999
