Please read carefully before use...
1-DESCRIPTION OF YOUR APPLIANCE
•
Vision function :
The Vision system installed in your device gives
perfect epilation results first time. By diffusing an ultraluminous
halo on the skin, this system makes all your hair – even the finest,
shortest and fairest hairs – easier to see.
•
Pivoting head function:
For comfort of use, your appliance is fitted
with a pivoting head that adapts to every contour of the areas to be
shaved (legs, armpits, bikini line) for a smooth, efficient result.
•
Pain-relieving function:
Fresh Extreme is equipped with a high-
speed turbine which blows air onto the skin and cools it. This helps
to reduce the pain caused by epilation.
2-SAFETY
• For your safety, this appliance complies with the applicable stan-
dards and regulations (Low Voltage Directive, Electromagnetic Com-
patibility, Environmental...).
• Check that the voltage of your electricity supply matches the voltage
of your appliance. Any error when connecting the appliance can
cause irreparable harm, not covered by the guarantee.
• The installation of the appliance and its use must however comply
with the standards in force in your country.
• Never use if the appliance (depilator or adaptor) is damaged or in
the event of any damage caused by dropping the appliance (invisi-
ble damage may be dangerous).
• This appliance is not intended for use by persons (including children)
with reduced physical, sensory or mental capabilities, or lack of ex-
perience and knowledge, unless they have been given supervision or
instruction concerning use of the appliance by a person responsible
for their safety. Children should be supervised to ensure that they do
not play with the appliance.
• Stop using your appliance and contact an Authorised Service Cen-
tre if:
- your appliance has fallen,
- it does not work correctly.
• The appliance must be unplugged:
- before cleaning and maintenance procedures.
- if it is not working correctly.
- as soon as you have finished using it.
- if you leave the room, even momentarily.
• Do not use if the cord is damaged.
• Do not immerse or put under running water the appliance, even for
cleaning purposes.
• Do not hold with damp hands.
• Do not unplug by pulling on the cord, rather pull out by the plug.
• Do not use an electrical extension lead.
• Do not clean with abrasive or corrosive products.
• Do not use at temperatures below 0°C and above 35°C.
• When the depilator is in use, it must not come into contact with eye-
lashes, hair, clothes or any other objects, in order to avoid any dan-
ger of injury or blockage.
• Do not use the depilator:
- on your face
- on broken, burnt or sore skin
- on sensitive areas (varicose veins, moles, birthmarks, warts…)
- if you suffer from skin complaints, (eczema, inflam-mations, acne…).
If using on the bikini line, only use this appliance for the external area.
Do not use it for more intimate zones (pubic lips).
For hygiene reasons, it is advised that you do not allow anyone else
to use your appliance.
Guarantee
Your appliance is designed for use in the home only. It
should not be used for professional purposes. Any commercial use,
inappropriate use or failure to comply with the instructions, the ma-
nufacturer accepts no responsibility and the guarantee will not
apply. The guarantee becomes null and void in the case of improper
usage.
3-PREPARATION OF THE SKIN
Your skin must be clean and dry.
• Do not apply either cream or hydrating milk before depilation.
• If you previously used a razor for depilation:
- the first few times you use the depilator, your skin may feel more
sensitive, as shaving has made your hair thicker and stronger. This
sensation will lessen the more you use your depilator : the hair will
grow back less quickly and become thinner.
• Your depilator will be much more effective and easier to use if you
use it regularly.
We advise you to use your depilator as soon as your hair starts to
grow back.
4-SWITCH ON
Fig. 1
5-SWITCH OFF
Fig. 2
6-PEELING
Peeling will enable you to limits growth of subcutaneous hair if prac-
tised regularly.
We strongly recommend that you use the Exfoliator Head 2 days be-
fore using your epilator to avoid irritating your skin.
• And not to use a peeling gel or cream at the same time.
• Never carry out peeling on sensitive areas (armpits / bikini line /
face).
• After peeling, we advise you to wipe over the area with a moist flan-
nel to remove any dead skin Fig. 3. Dry the skin thoroughly after-
wards.
• Method :
- Press the release button to remove the epilator head. Fig. 4
- Clip the Exfoliator Head to the epilator. Fig. 5
- Select speed 1.
- Start exfoliating with a slow, gentle up and down movement. Fig. 6
When using the Micro-Peeling function for the first time or if your
skin is very delicate, we recommend:
1. skin is wet before peeling, use cotton wool or a flannel to do
this
2. making slow and gentle rotating movements when using the
appliance
3. not to use the appliance more than twice on the same area.
• Replacing the exfoliating band
- Press the release button to remove the Exfoliator Head from the epi-
lator. Fig. 7
- Using the plastic end of the cleaning brush unclip the band as fol-
lows:
1. Turn the Exfoliator Head over and hold it in place by gripping the
edges between your thumb and forefinger. Fig. 8
2. Turn the band so that its groove comes round to the central posi-
tion.
3. Insert the end of the cleaning brush in the groove and push to eject
the band.
4. Insert the new band by slotting the fins (b) of the exfoliator unit in
the groove of the band and pushing until it clicks! Fig. 9 & 10
7-LEG HAIR REMOVAL
For optimum epilation, we recommend that you tilt the epilator
slightly towards your skin in the direction of epilation, as shown in the
diagram. Fig. 11
- Select speed 1 or 2. Fig. 12
- The switch must always remain visible during use.
- Shave against the lie of the hair, slowly and without pressing, with
the shaver perpendicular to your skin. Fig. 13
8-HAIR REMOVAL FROM SENSITIVE AREAS
We recommend that you use the "sensitive areas" accessory when
removing hair in the armpits and around the bikini line.
This accessory has been designed to reduce the number of active
tweezers, for a more gentle hair removal. Fig. 14
For optimum epilation, we recommend that you tilt the epilator
slightly towards your skin in the direction of epilation, as shown in
the diagram. Fig. 15
• Preparing the area where you want to remove hair:
- If the hairs are long trim to approximately 1cm.
- Dry the area thoroughly to ensure any trace of deodorant or pers-
piration are removed.
Armpits and bikiniline epilation
- Fit the Sensitive areas accessory (12) onto the epilator head and
push in until you hear a click.
- Select speed 1.
First from bottom to top ...Then from top to bottom. Fig. 16
Important :
a) Keep your arm raised and stretched throughout the hair removal
process. Fig. 17
b) Stretch the skin to make it easier.
Important:
Make sure the skin is stretched properly. Fig. 18
Shave against the lie of the hair, slowly and without pressing, with
the shaver perpendicular to your skin.
2-With the shaver head :
• Operating instructions:
- Remove the epilator head by pressing the ejection button. Fig. 19
- Fit the shaver head (13) onto the appliance. Fig. 20
- Set the switch to position 2.
- After use, stop the appliance.
- Remove the shaver head by pressing the ejection button. Fig. 21
9-TRIM AND EVEN OUT HAIR IN THE BIKINI
AREA
Put the bikini line trimmer head in place (20). Your bikini line trimmer
head is equipped with 3 combs to lift long hairs for cutting by the
blade.
Choose the desired comb before switching the appliance on.
IMPORTANT
For your first use, we advise you to use the comb for the longest cut-
ting length.
- If you want a hair length of approximately 9 mm, use the largest
comb.
- If you want a hair length of approximately 3 mm, use the smallest
comb.
- If you want a hair length of approximately 6 mm, use the medium-
sized comb.
Slide the comb into the two grooves on the trimmer head (a), then set
the switch to 2. Fig. 22
Hold the appliance upright so that you can see the appliance name,
and move it slowly against the hair.
IMPORTANT
If your skin becomes irritated, apply some talc after use.
• For a neat bikini outline
If you want a closer shave, use the bikini line trimmer head without
the comb:
Stop the appliance by pressing 0 and unplug it.
Push to remove the comb (b). Fig. 23
Then switch on the machine by selecting speed 1 or 2.
Hold the appliance upright and move it slowly against the hair.
IMPORTANT For greater effectiveness, pull hair outward with the
other hand to make it stand out. This will give you a more precise
shave with little irritation.
10-CLEANING THE APPLIANCE
• Cleaning the epilator head
1. Unplug the epilator. Fig. 24
2. Press the release button on the head and remove the epilator head.
Fig. 25
3. Rinse the epilator head under cold running water by turning it for
5 to 10 seconds. Fig. 26
4.
Shake the epilator head vigorously and dry it with a towel before
fitting it to the epilator again.
Fig. 27
You can also use the small cleaning brush supplied. Fig. 28
• Cleaning the shaving head
- Stop and unplug the device.
- Remove the protective hood (18). Fig. 29
To do so: press the release buttons and pull upwards. You will re-
move the protective hood (18) from the blade block (17).
- Carefully remove the hairs by blowing on and around the micro grid
(14)
Never use the small brush for cleaning the micro grid (14).
You can also run the protective hood (18) and the blade block (17)
under running cold water to remove all the hair. Shake the parts well
and then dry them using a towel without pressing down on the micro
grid before reassembling them.
- Put the protective hood (18) back on the blade block (17). You will
hear a click. Fig. 30
DO NOT PRESS ON THE MICRO GRID WHEN PUTTING IT BACK INTO
PLACE
.
Do not apply alcohol to the body of the appliance in order to avoid
damaging its colours.
Do not use a metal or sharp tool.
• Clean the trimmer head
Stop the appliance and unplug it.
Press the release button to remove the epilator head.
Remove the comb and clean hair from the trimmer head with the
brush.
Rinse the trimmer head under cold tap water for 5 or 10 seconds. Fig. 31
Shake the trimmer head vigorously and dry it with a towel.
IMPORTANT Systematically clean the appliance’s trimmer head after
each use.
The appliance must not be submerged in water. It must not be used
in the shower or bath.
• Cleaning sensitive area accessory
Fig. 32, 33
• Cleaning the Exfoliator Head
We recommend that you change the exfoliating band after three ses-
sions of exfoliation or when it is worn out.
!
Do not clean the band under running water.
Fig. 34
11-LUBRICATION
To keep your appliance working effectively, the blades should be oiled
regularly (notably after washing in water) using the lubricant supplied
or, if you have none, with the type of oil used for sewing machines.
Stop the appliance and unplug it.
Clean the trimmer head with the brush.
Lubricate the blades : one drop is enough. Fig. 39
Run the trimmer for a few seconds.
Clean the excess oil off with a cloth.
IMPORTANT
Avoid applying alcohol to the body of the appliance so as not to fade
its colours.
12-SKIN CARE
Small red spots may appear. They will disappear quickly.
For this reason it is preferable to use your depilator in the evening.
If necessary, apply calming cream after depilation.
13-ENVIRONNEMENT PROTECTION FIRST!
GB
www.rowenta.com
1
2
1
8
0
0
11
8
2
1
5
/
0
3
-1
0
Fig. 1
1
2
Fig. 2
Fig. 3
Fig. 4
Fig. 5
Fig. 6
Fig. 7
a
Fig. 8
b
Fig. 9
CLIC!
Fig. 10
Fig. 11
Fig. 12
Fig. 13
CLIC!
Fig. 14
Fig. 15
Fig. 16
Fig. 17
Fig. 18
Fig. 19
Fig. 20
Fig. 21
Fig. 22
Fig. 23
1
2
Fig. 24
Fig. 25
Fig. 26
Fig. 27
Fig. 28
Fig. 29
Fig. 30
Fig. 31
Fig. 32
Fig. 33
Fig. 34
Fig. 35
Fig. 36
Fig. 37
Fig. 38
Fig. 39
1-Pivoting head
2-Depilator head
3-Tweezers
4-Massaging beads
5-Exfoliator head
6-2 exfoliating bands
7-Release button for removable
head
8-Cap
9-2-speed and stop switch
10-Cleaning brush
11-Adaptor
12-Sensitive areas accessory
13-Shaving head
14-Micro grid
15-Clipper
16-Release buttons
17-Blade unit
18-Protective hood
19-Lubricating oil
20-Bikini trimmer head
a- Trimmer head with ceramic
blade
b- Interchangeable combs (3,
6, 9 mm)
21 - Vision
22 - Pain-relieving function
Your appliance contains valuable materials which
can be recovered or recycled.
Leave it at a local civic waste collection point.
2
9
8
2
10
11
7
1
4
3
21
22
12
13
19
6
5
20
a
b
16
17
15
18
16
14
IFU_RO_EP8451EO_1800118215_mise en page 29/01/10 14:26 Page1
