Your tent will have:
• Flysheet with sewn in groundsheet
• 2 inner tents
• Inner tent divider curtain
• 5 long fibreglass angled poles for the tunnel
• 2 small fibreglass poles for the door canopies
• Bag of metal tent pegs
Buckland 8
Person Tent
www.royal-leisure.co.uk
1.
Assemble the poles and lay them out on the ground.
2.
Open out the flysheet and lay it out with the doors pointing in the desired direction.
3.
Insert the red colour coded poles through the corresponding coded sleeve on the flysheet, then insert the blue
colour coded poles through the corresponding coded sleeve.
4.
Loosen any tension straps attached to the ring and pin system.
5.
Insert the metal pin from the ring and pin system into the bottom of the poles.
6.
Push these poles into an arch from the opposite ends and locate pole ends into corresponding metal pin. To
avoid excess strain on poles and tent material, it is advisable to have assistance to hold these poles upright when
forming the dome.
7.
Clip all flysheet pole clips onto poles.
8.
Next take the 2 small fibreglass poles and insert them, once assembled, into the black pole sleeve above each
door. Place one end of the pole into the metal eyelet at the side of the door and then the other side to secure in
place.
9.
Starting at the back of the tent. Peg down the pegging points at the rear corners.
10.
Pegs should be positioned at a 45˚ angle to the tent to ensure maximum grip.
11.
Pull the tent forward until taut and peg out the corners at the front of the tent. Ensure that the sides and rear of
the tent form straight lines and the groundsheet is flat and wrinkle free. At this stage, re-peg any corners where
the groundsheet may be creased.
12.
Peg out the remaining poles and pegging points.
13.
Peg out ALL guy ropes at 45˚ angles from the tent.
14.
To hang the inner tents start at the back and connect the rear floor clips to the loops attached to the
groundsheet. Work up the inner tent connecting all the rear connectors, then connect the front tension straps
and connectors. (Several of the clips are colour coded to help identify the correct position).
Insert the divider curtain if required.
185
215
200
280
310
740
210
125
115
115
115
115
140
140
Weight:
33.7kg
302630 - Buckland 8 Person Tent Instructions.indd 1
20/10/2017 16:09
