70-210201-13 V1.0
Reference Guide
HDBaseT Class B Extender Set
VHP-1x
It’s Under Control
®
The VHP-1x HDBaseT™ Class B HDMI Extender Set provides a convenient and cost effective
solution for delivering video up to 70 meters for 1080p or 40 meters for 4K, without compromising
audio or video quality. The transmitter and receiver also transmit IR signals through the same
category cable to enable control the remote display and video source.
Key Features
The VHP-1x provides superior quality and reliability as well as these specific features:
Extends HDMI video 1080p up to 230ft (70m) and 4K up to 131ft (40m) over Cat5e/6/7 cable.
Wall mountable (mounts sold separately)
Low power consumption
Supports ultraHD 4K transmission, 1080p@60Hz/36-bit, 720p and VGA-WUXGA formats.
Bi-directional IR transmission
Full HDMI audio support
HDCP 2.2 compliant
Power supply included (transmitter) with Power over HDBaseT to receiver.
Safety Suggestions
Read and Follow Instructions. Read all safety and operating instructions before operating the unit.
Retain Instructions. Keep the safety and operating instructions for future reference.
Heed Warnings. Adhere to all warnings on the unit and in the operating instructions.
Heat. Keep the unit away from heat sources such as radiators, heat registers, stoves, etc., including amplifiers that produce heat.
Power Sources. Use only power sources of the type described in the operating instructions, or as marked on the unit.
Water and Moisture. Do not use the unit near water—for example, near a sink, in a wet basement, near a swimming pool, near an open window, etc.
Object and Liquid Entry. Do not allow objects to fall or liquids to be spilled into the enclosure through openings.
Servicing. Do not attempt any service beyond that described in the operating instructions. Refer all other service needs to qualified service
personnel.
Damage Requiring Service. The unit should be serviced by qualified service personnel when:
Objects have fallen or liquid has been spilled into the unit.
The unit has been exposed to rain.
The unit does not appear to operate normally or exhibits a marked change in performance.
The unit has been dropped or the enclosure has been damaged.
Limited Warranty
RTI warrants new products for a period of three (3) years from the date of purchase by the original purchaser (end user) directly from RTI / Pro
Control (herein referred to as “RTI”), or an authorized RTI dealer. Warranty claims may be initiated by an authorized RTI dealer using the original
dated sales receipt or other proof of warranty coverage. In the absence of the receipt of purchase from the original dealer, RTI will provide warranty
coverage extension of six (6) months from the date code of the product. Note: RTI warranty is limited to the provisions set forth in this policy and
does not preclude any other warranties offered by third parties who are solely responsible for those other warranties.
Except as specified below, this warranty covers defects in product material and workmanship. The following are not covered by the warranty:
• Damages caused by accident, misuse, abuse, neglect or acts of God.
• Cosmetic damage, including, but not limited to, scratches, dents and normal wear and tear.
• Failure to follow instructions contained in the Product Installation Guide.
• Damages due to products used in an application or environment other than that for which it was intended, improper installation procedures
or adverse environmental factors such as incorrect line voltages, improper wiring, or insufficient ventilation.
• Repair or attempted repair by anyone other than RTI and Pro Control or authorized service partners.
• Failure to perform recommended periodic maintenance.
• Causes other than product defects, including lack of skill, competence or experience of user.
• Damage due to shipment of this product (claims must be made to the carrier).
• Altered unit or altered serial number: defaced, modified or removed.
RTI is also not liable for:
• Damages caused by its products or for failure of its products to perform, including any labor costs, lost profits, lost savings, incidental
damages, or consequential damages.
• Damages based upon inconvenience, loss of use of the product, loss of time, interrupted operation, commercial loss, any claim made by a
third party or made on behalf of a third party.
• Loss of, or damage to, data, computer systems or computer programs.
RTI’s liability for any defective product is limited to repair or replacement of the product, at the sole discretion of RTI.
In cases where the warranty policy conflicts with local laws, the local laws will be adopted.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the Federal Communications
Commission (FCC) Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. Any
changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the device.
This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and the receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
1.
This device may not cause harmful interference.
2.
This device must accept any interference received including interference that may cause undesired operation.
This device complies with Industry Canada license-exempt RSS standard(s). Operation is subject to the following two conditions:
1.
This device may not cause harmful interference.
2.
This device must accept any interference received including interference that may cause undesired operation.
Cet appareil est conforme avec Industrie Canada exempts de licence standard RSS (s). Son fonctionnement est soumis aux deux conditions
suivantes:
1.
Ce dispositif ne peut causer des interférences nuisibles.
2.
Cet appareil doit accepter toute interférence reçue y compris des interférences qui peuvent provoquer un fonctionnement indésirable.
DECLARATION OF CONFORMITY (DOC)
The Declaration of Conformity for this product can be found on the RTI website. (www.rticorp.com/declaration)
FCC Compliance Statement
If you are encountering any problems or have a question about your RTI product, please
contact RTI Technical Support for assistance (see the Contacting RTI section of this guide for
contact details).
RTI provides technical support by telephone or e-mail. For the highest quality service, please
have the following information ready, or provide it in your e-mail.
• Your Name
• Company Name
• Telephone Number
• E-mail Address
• Product model and serial number (if applicable)
If you are having a problem with hardware, please note the equipment in your system, a
description of the problem, and any troubleshooting you have already tried.
Please do not return products to RTI without a return authorization.
Service & Support
For news about the latest updates, new product
information, and new accessories, please visit our
web site at: www.rticorp.com
For general information, contact RTI at:
Remote Technologies Incorporated
5775 12th Ave. E Suite 180
Shakopee, MN 55379
Tel. (952) 253-3100
Fax (952) 253-3131
info@rticorp.com
Contacting RTI
Copyright © 2018 • Remote Technologies Incorporated • All rights reserved.
Industry Canada Compliance Statement
