background image

-OR-

DM1U

DM1F

USB Type A to 

mini-B cable

IEEE 1394a 

(FireWire) cable

(DM1F only)

IEEE 1394b 

(FireWire) cable

(DM1F only)

Soft case

Screws

Quick Start Guide

Press the lid down while sliding it away 

from the end with the USB port. The 

enclosure contains a circuit board and a 

package of four screws.

Carefully remove the circuit board from the 

enclosure, then insert your 2.5" hard drive’s 

SATA and power connectors into the SATA 

and power slots on the circuit board. Make 

sure that the connectors are fully inserted.

Quick

Start

Guide

2.5" Hard Drive Enclosure

Contact Us

Important:

 Contact Sabio 

before

 returning product to the retailer.

support@sabioproducts.com

402-494-6013

1

2

3

4

5

6

Package contents

Assembling the 

enclosure

Connecting to a 

computer

Models and features

2.5” HDD USB 2.0 enclosure kit

DM1U

USB mini-B port

Case screws

2.5” HDD USB 2.0/FireWire 400/FireWire 800 enclosure kit

DM1F

USB mini-B 

port

FireWire 400 

Port

FireWire 800 

Port

Case screws

1

2

www.sabioproducts.com

Turn the hard drive assembly over, then 

secure the circuit board to the hard drive 

using the two large screws in the package. 

Make sure that the circuit board and hard 

drive remain aligned while you tighten the 

screws.

Carefully slide the assembly into the 

enclosure so that the port(s) on the circuit 

board slide into the port opening(s) on the 

enclosure, and the two posts in the 

opposite end of the enclosure align with 

the two holes at the bottom of the drive.

Place the lid on top of the enclosure, 

making sure that the two copper screw 

holes in the enclosure are aligned with the 

screw holes on the circuit board, then 

press the lid down while sliding it toward 

the end with the USB port. Make sure that 

the lid is flush with the enclosure case.

Secure the lid to the case using the two 

small screws in the package. 

LED

Turn on the computer, then connect the USB 2.0 or IEEE 1394 

(FireWire) cable to the corresponding port in the enclosure.

Connect the USB  2.0 or IEEE 1394 (FireWire) cable to an 

available port on the computer. The enclosure is automatically 

detected by the computer, and the enclosure’s LED activity 

indicator shines steadily blue. The same LED flashes while the 

drive is being accessed.

Caution

: The enclosure should be connected to the computer 

using only one type of cable. Connecting more than one cable 

may cause data errors and damage the enclosure’s circuit board 

and hard drive.

Note

: FireWire cables can only be connected to the DM1F 

enclosure.

Reviews: