www.safetoe.net
Start With Comfort, More Than Safety
Safety Respirator
l
Mask Holder : Comfortable Liquid Silica Gel
l
Face Protector: Anti-Fog Wide View PC
l
Filter : Replaceable Carbon Filters
l
Band: Ajustable Elastic Head Band
l
Shape : Full Face Respirator Design
l
GB2890-2009
l
Application : Chemical, Construction, Road & Building Workers, Woodworking, Mining, Casting, Grinding,
Food & Cleaning Industry, Electronics, Most Dust Generated Workplaces etc
GM8000 Full Respirator With Carbon Filters
Users Instruction:
1.) FITTING INSTRUCTIONS
：
⚫
This respirator is a double filtering device. Please assemble two filters
before wearing.
⚫
Loosen the elastic straps. Place the cradle suspension over the crown of
your head.
⚫
Grasp the front of the face piece and position face piece over your mouth
and nose, then grasp bottom elastic headband straps and buckle them
behind the neck.
⚫
Pull the top straps and the bottom straps uniformly until the respirator
fits securely and comfortably against your face. If necessary, readjust the
straps.
2.) LIMITED TO USE:
⚫
This respirator does not supply oxygen. Please do not use in atmospheres
containing less than 18% oxygen.
⚫
Do not use this respirator in oxygen enriched air. It becomes hazardous when
the concentration increases. There is no sharp limit even a few percent more
increases the hazard. Fires in oxygen enriched atmosphere starts easily with
electrostatic sparks and are very intense.
⚫
Do not use this filter in explosive atmosphere.
⚫
Do not use when concentrations of contaminants are immediately dangerous
to life and health, or unknown contaminants;
⚫
Do not abuse or misuse this respirator.
⚫
Beards/moustache at the sealing area of the mask can cause leaks.
Therefore it is unlikely that the requirements for leakage will be achieved
if these facial hair passes under the face seal. Always make sure the
respirator forms a tight seal and the cartridges and/or filters are attached
prior to entering a hazardous atmosphere.
3.) LIFESPAN
The Respirator can be expected to remain in service for 3 years or more,
when it is in well stored condition.
4.) CLEANING & MAINTENANCE
⚫
Cleaning is recommended after use; Remove the cartridges or filters
before cleaning.
⚫
Clean the face piece (excluding cartridges and filters), with medical grade
alcohol, and let dry in room temperature
.
5.) STORAGE
The cleaned respirator should be stored away in its original packaging or in
a container box from contaminated areas when not in use. Always
remember to store away from direct daylight or any source of heat.
