TM
1
Assembly Instructions
9049 Tyler Blvd. • Mentor, Ohio 44060
Phone (440) 974-8888 • Fax (440) 974-0165
Toll-Free Fax 800-841-8003 • saltdogg.com
WB400
Walk Behind Drop Salt Spreader
Check contents of box against the parts list to
make sure all components are included. When
ordering replacement or spare parts refer to the
parts list for part numbers.
Tools Needed For Assembly
• (2) 7/16 Wrenches
• (2) 1/2 Wrenches
• (1) 5/32 Allen key
Assembly
Attaching the supports, and Hopper.
(see fig. 1)
1.
Remove contents from box and place the
preassembled portion of the spreader upright on its
wheels
2.
Assemble left hand support arm (3016744) & line
up the holes, fasten with (3) 3/8-16 bolts, washers,
lock washers, and nylock nuts. Threads of bolts
should face away from wheels. Tighten fasteners.
3.
Assemble left hand support arm (3016745) & line
up the holes, fasten with (3) 3/8-16 bolts, washers,
lock washers, and nylock nuts. Threads of bolts
should face away from wheel. Tighten fasteners.
Attaching the Linkage Rod
(see fig. 2)
1.
Insert the 90 degree end of the linkage rod in
the holes located in the lower middle of the hopper
frame. The rod will remain loose until the handles
are attached.
HOPPER ASSEMBLY
3016745
RH SUPPORT
3 BOLTS
PER SIDE
3016744
LH SUPPORT
Fig. 1
ROD (3016748)
INSERT INTO HOLES AS SHOWN
Fig. 2