Guide No.: GH68-12483A
04/2007.Rev.1.1
Quick Start Guide
Samsung
Bluetooth
®
Headset
WEP420
Thank you for purchasing the Samsung Bluetooth
Mono Headset WEP420. We hope you will be
delighted with its operation.
Take a moment before you get started to
familiarize yourself with your new headset.
Make sure you have the following items with your
headset:
Make sure you have the following items with your
headset:
Charging Cradle, Travel Adapter, User’s Guide
Charging Cradle, Travel Adapter, User’s Guide
Check the accessories
Check the accessories
Charge your headset
Charge your headset
Charge the headset's battery fully before using
the headset for the first time.
1
Insert your headset into the slot of the
charging cradle.
2
Plug the travel adapter into the jack on the
charging cradle.
3
Plug the travel adapter into the electrical
outlet.
• Charge the headset until the red light on the
headset turns to blue.
• The headset will be fully charged in
approximately 2 hours.
Before you can use your headset, you must pair it
with your phone.
Put your headset in
pairing mode
Turn on Bluetooth on your
phone and pair with headset
Your phone and headset are now paired and
ready to make and receive calls. To confirm
they are operating properly, make a call:
1
Place the headset over your ear.
See Wear the headset on the reverse
side of this guide.
2
On your phone, make a call to the number
you want.
3
If your phone and headset are successfully
paired, you will hear ringing on the headset.
After you have successfully paired your phone
and headset, you do not need to repeat these
initial setup steps each time you use the
headset.
Test and use
Using your WEP420
See Features and Functions Guide
on the reverse side of this guide
for information on using your
WEP420.
1
Ensure that the headset is off (see Turn
headset on/off on the reverse side of this guide).
2
Press and hold the Multi-Function button until
the indicator light turns on in blue
(approximately 8 seconds).
Before using your headset
Multi-Function
button
Headset cover
Volume control
buttons
Indicator light
Earpiece
Microphone
4
Remove the travel adapter from the charging
cradle.
• The headset cannot be used while charging.
• Use only a Samsung-approved charger or adapter.
Start here
Charge your headset
Put your headset in pairing mode
Turn on Bluetooth on your phone and
pair with headset
Test and use
Get connected in 4 quick steps
Headquarters:
1301 East Lookout Drive Suite 150
Richardson, TX 75082
Internet Address:
http://www.samsungmobileusa.com/
accessories
Customer Care Center:
1-888-987-4357
Earhook
The items supplied with your headset may vary, depending
on your country or service provider.
1
Set your Bluetooth phone to discover the
headset by following your phone's guide.
Typically, the steps involve going to the Settings,
Connection, or Bluetooth menu on your
phone and then selecting the option to discover
Bluetooth devices.
Your phone will find the Samsung WEP420
headset and ask if you want to pair with it.
Confirm this by pressing the Yes or OK key.
2
Enter a passkey or PIN, 0000 (4 zeros), then
press the Yes or OK key.
• Bluetooth version: 2.0 (compatible with devices of
Bluetooth version 1.1 or higher)
• Supported Bluetooth Profiles:
- Headset Profile
- Hands-Free Profile
