1
Instructions for Installing & Programming the Mini HotDialer™
Install the Mini HotDialer™ dialer as shown in the picture below, if it’s not pre-installed in a phone.
The Mini HotDialer™ only works on standard analog telephone lines, analog station ports and analog telephones.
The Mini HotDialer™ is telephone line powered and has non-volatile memory so it will not lose its programming when
unplugged from the phone line.
Program Quick Reference:
To Enter Programming:
Lift the telephone handset and dial the default programming password: XXX You’ll hear one beep. You are now in
programming mode and can enter any valid program Register.
If you enter the password incorrectly you won’t hear the one beep, and you’ll have to hang up the phone for the amount
of time programmed in Register 16 (800ms by default). Then lift the handset again and enter the program password
correctly.
To exit programming dial 99, wait for a beep, and hang up.
If you have previously programmed the Mini HotDialer™ to dial when the handset is lifted you will have to wait for it
to finish dialing before entering program mode!
If you hear 4 beeps this means a program entry was incorrect.
Programming:
Steps in programming the Mini HotDialer™:
1. Enter programming mode (see above)
2. Dial the Register number (like 01 from the above list) and you will hear 1 beep
3. Dial the program data
4. Dial # # to save the Register entry you just programmed, and you’ll hear 2 beeps
Example: 01 beep 18005551212 # # beep beep. This programs the Hotline Number to Dial with 1-800-555-1212
