background image

PARTS LIST

Following parts are contained in the packing.

·  LENS                

· LENS MOUNTING SCREWS          
· DRIVER                                          
· LIGHT-BLOCK SHEET 

· LENS COVER (UPPER · LOWER )   

NOTES ON LENS INSTALLATION

LCD PROJECTOR LENS

MODEL NO. LNS-W02/T02

LNS-W02K/T02K Series

Lens installation should be performed by the qualified service personnel.

It should be followed by this procedure precisely.

Before attempt to install the lens, confirm the model number (both the LCD

projector and the lens) and use the proper lens.

If you have any questions, contact to the dealers.

Following checks and confirmations should be taken for safety.

Check the following things by the time of the cabinet assembly after the
lens installation.

1. Confirm the lens is securely fixed by 4 screws.

2. Wiring must not be tangled in the gear of the lens motor or the other 

mechanical part.

3. There is no missing part, or no loosing mounting part.

1AA6P1P2289-- (ICSC)

1 piece
6 screws (2 for spare)
1 piece
1 sheet
1 set

LENS REPLACEMENT AND
INSTALLATION PROCEDURE

Summary of Contents for LNS-T02 Series

Page 1: ...m the model number both the LCD projector and the lens and use the proper lens If you have any questions contact to the dealers Following checks and confirmations should be taken for safety Check the following things by the time of the cabinet assembly after the lens installation 1 Confirm the lens is securely fixed by 4 screws 2 Wiring must not be tangled in the gear of the lens motor or the othe...

Page 2: ... COVER C B D D COVER PLATE REMOVE THE LENS COVER At the step insert the light block sheet in the same position as the removed cover plate has been placed Two screws are not used Use the light block sheet included with lens 5 REMOVE THE COVER PLATE OF THE LENS COVER See figure 3 Set the light block sheet so that the large rounder side is set over the lens SCREWS LIGHT BLOCK SHEET Fig 2 LENS COVER R...

Page 3: ...G BRACKET LENS MOTOR LEAD CONNECTOR K16B D D D D B A LENS MOTOR Fig 4 This part wiring should not be tightened C A INSTALL THE LENS See figure 4 5 3 1 Remove protective caps front and back on the lens 2 Mount the lens at the lens mounting bracket with screws 4 screws included with the lens Use the driver included with the lens to fasten the screws After using save it for latter use See figure 5 3 ...

Page 4: ... the installation of the light block sheet is incorrect there will be the space between lens and the lens cover so that it will be the cause of leakage of light or the dust entering at the main cabinet 1 Insert the upper part lens cover and fix them with screws A 4 screws Fig 7 UPPER LENS COVER LOWER LENS COVER A A B LIGHT BLOCK SHEET Insert into the slot Set the light block sheet so that the larg...

Reviews: