Quick Start Guide - qMOD300
Copyright 2021 System Q Ltd
1
Digital HD Modulator
ScatterBox is a registered trademark of System Q Ltd
MOD300 - Quick Start Guide
www.systemq.com/PDF
/manual/xMOD300.pdf
The MOD300 converts a HDMI output from a DVR (or other equipment such as a Satellite box) into a
digital RF signal or “Digital TV channel”. It can then be viewed on a DVB-T equipped TV.
Note: The MOD300 has to process and digitise the HDMI input and this creates a delay or “latency” in its
output, this is typically in the region of 1 second.
1) Remove all the power to the modulator when connecting or removing cables.
2) Connect a HDMI cable from the DVR / NVR (or other video equipment) to the HD IN of the MOD300.
3) When combining the RF signal of a TV aerial and the MOD300, connect the TV aerial coax (f-
connector) to the RF.IN port. If using a masthead amplifier, see the full manual.
4) Connect a coax (f-connector) to the RF.OUT port direct to a TVs aerial socket or to a distributor to
multiple TVs.
5) Connect the 12V DC power supply to the MOD300, then re-tune the TVs.
