Contents
Specifications . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1
Special Precautions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2
Getting to Know the FCR1 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3
Installation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4-6
SPECIFICATION AND INSTALLATION GUIDE
FCR1
Field Cut Riser System
For Use with Grease Interceptors Models
GB1, GB2 and GB3
9500 Woodend Road | Edwardsville, KS 66111 | Tel: 913-951-3300 | www.schierproducts.com
© Copyright 2019 Schier, All Rights Reserved
MODEL NUMBER:
FCR1
DESCRIPTION:
12" Field Cut Riser System
PART #: 8010-005-01
DWG BY: B. Karrer
DATE: 4/22/2019
REV:
ECO:
Notes
ø 23-3/4"
ø 21-7/8"
ø 21-1/2"
Riser Height Needed
Risers Required
2-1/8" - 12"
FCR1
>12" - 25"
FCR1 (x2)
1. Rotationally molded polyethylene body
2. Injection molded polypropylene top cover ring
3. EPDM sponge tank-to-riser gasket
4. Silicone fin riser body to riser top gasket
5. Unit weight: 10 lbs.
6. Risers not designed to hold water
Engineer Specification Guide:
Field-cut adjustable riser system to consist of rotationally molded polyethylene
body, injection molded polypropylene top cover ring, EPDM sponge gasket at
bottom, silicone fin gasket at top flange. Risers shall allow field adjustability of
cover to grade.
Installation Note
Minimum install height: 2-1/8". Maximum install height: 12".
Riser system may be stacked no more than two units high to a maximum of 25"
extension. Access to internal components will not be compromised.
12" Max
Extension
12-3/4"
Overall
2-1/8" Min
Extension
