KP2000E/EM Series Style Keypad
Installation and Programming Instructions
Models KP2000EXX and KP2000EMXX
23852973
Specifications
Parameter
Specifications
Voltage
Requirements
10-30 VDC; 12-24VAC
Keypad Current
Requirements (Max)
VDC
VAC
10V: 85mA
12V: 150mA
30V: 115mA
24V: 200mA
Relay Contact Rating 2A @ 30VDC (Main & Aux)
REX Input
Normally Open Dry Contact
Door Position Switch
Input
Normally Closed Dry Contact
Mechanical
Dimensions
4.50” H x 2.75” W x 0.60” D
Environment
Indoor or Outdoor
Temperature
Tolerance
-31°F to 151°F (-35ºC to 66°C)
Front End Cable
Type
Stranded and Shielded
Front End Distance
and Wire Gauge
1000 Ft. – 18AWG; 500 Ft – 20 AWG; 250
Ft. – 22 AWG
Firmware Version
1.0x (“1” is the major version; “0” is the
minor version; “x” is a minor version,
reserved for bug fixes, which is indicated
with a letter, such as “a”.)
Keypad Operating Modes
The KP2000E/EM Series keypad has two operating modes:
Standalone Mode and Wiegand Front End Mode. Below is a brief
explanation of each mode. Refer to the programming section for
details about selecting each mode.
Standalone Mode:
By default, the keypad is programmed for Standalone Mode. In this
mode, all the users and other programming options are maintained
within the keypad and no additional controller is required. The lock
and all other inputs and outputs are connected directly to the keypad.
Wiegand Front End Mode:
In Wiegand Front End mode, a separate UL Listed compatible
Wiegand Access Control panel is required. When you enter a code on
the keypad it is then sent to the control panel as Wiegand card data,
depending on which format you’ve programmed it for. The control
panel maintains the users and programming options and makes all
the access control decisions. The locking device and all inputs and
outputs are connected to the control panel.
Mounting the Keypad
The keypad is designed to be flush mounted using a standard UL
Listed single-gang electrical box. Mounting height can vary depending
on requirements. An appropriate range is typically between 48 and 52
inches on center off the floor.
For outdoor installations, use a UL Listed weatherproof back box and
seal the wire entry locations with silicone and provide a drain hole.
For additional protection, install the provided foam gasket between
the keypad and the back box. In addition, use the anti-oxidant grease
pack for the wire harness connectors.
48 - 52”
Circuit Board Diagram
1
P2
Main
Relay
Aux
Relay
1
J2
1
J3
Note: J3 is NOT USED
