Your Scientemp freezer has been pre-programmed at the factory and ready for use.
You only have to:
1) Plug your freezer into its own dedicated circuit and
2) Set your desired temperature on the controller
~~
To set the desired set point temperature, press and hold the * button, then while holding down the * press the UP
arrow to increase the set point temperature or press the DOWN arrow to decrease the set point temperature.
•
When uncrating, do not discard the Dark Grey Styrofoam Sublids inside the
freezer.
*The Sublids are necessary to maintain correct temperature, moisture control and economy of
operation.
•
Provide at least 3” of space around the freezer for ventilation. Avoid placing
the freezer in locations exposed to direct sunlight, heat registers or any other
heat source.
•
Alarm On/Off switch should remain in the “Off” position until the freezer
reaches desired set point temperature. When the temperature has been
reached, turn the alarm switch to the “On” position.
•
Cabinet should not be loaded with product until the cabinet has operated for
24 hours at the desired set point temperature.
Maintenance tips for your Scientemp Freezer:
•
Regularly remove any frost build up by using a plastic/wooden scraper.
•
Check and replace batteries on Alarm Signal System and Chart Recorder (if
equipped) on a regular bases.
•
Refrigeration compartment of the freezer, should be cleaned of dust and
debris about once a year (or more often if freezer is located where excessive
dust and dirt may occur)
~~This can be done by vacuuming carefully or by using forced air to blow the debris off.
(*) The freezer must be unplugged or removed from electricity before servicing.
3565 S. Adrian Hwy ~ Adrian, MI 49221-9253 ~ 1-517-263-6020 ~ fax 517-263-5492 ~ toll-free 800-968-2653
S C I E N T E M P C O R P .
Medical Freezers ~ Pharmacy Freezers ~ Culture Storage Freezers ~ Blood Storage/Blood Plasma Freezers
Adhesive Storage Freezers ~ Industrial/Manufacturing Freezers ~ Explosion Proof Freezers
Summary of Contents for 43-1.7A
Page 9: ......
Page 10: ...17B 3 1 14 4 5 6 10 9 14 15 17A 18 13 7 19 13 8 9 16 2 12 ...
