background image

QUICK START GUIDE

QUICK START GUIDE

1.  Solder a high quality battery connector to the ESC.
2.  Mount the ESC and motor into the car.
3.  Connect the 3 motor wires in to the ESC.
4.  Connect the ESC Rx lead to CH2 on your receiver.
5.  Make sure the ESC’s switch is off.
6.  Connect a battery.
7.  Calibrate your ESC to your radio by holding full throttle on 

your transmitter then turn the switch ON.

8.  After a few seconds you’ll hear multiple tones and the red 

LED will come on. 

9.  Now hold full brake and after a few seconds you’ll hear 

multiple tones and the yellow LED will come on. 

10. Now relax to neutral and after a few seconds you’ll hear 

multiple tones and ALL the LEDs will light up.

11. A few seconds later the ESC will arm with a double tone and 

you’re ready to go!

Revised 03/2017 

Cop

yri

ght 2

017 © C

ast

le C

rea

tio

ns, I

nc.

 

PKG: 057-0206-03

Reviews: