20V CORDLESS GLUE GUN - BODY ONLY
MODEL NO:
CP20VGG
Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these instructions,
and properly maintained, give you years of trouble free performance.
IMPORTANT:
PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
1. SAFETY
1.1.
GENERAL SAFETY
9
Familiarise yourself with this products application and limitations, as well as the specific potential hazards peculiar to the glue gun.
WARNING!
Disconnect the charging lead before changing accessories, servicing or performing any maintenance.
9
Maintain the glue gun in good condition (use an authorised service agent).
9
Replace or repair damaged parts. Use recommended parts only. Unauthorised parts may be dangerous and will invalidate the
warranty.
WARNING!
Always wear approved eye or face protection when operating the glue gun.
9
Keep the work area clean, uncluttered and ensure there is adequate lighting.
9
Remove ill fitting clothing. Remove ties, watches, rings, and other loose jewellery, and contain and/ or tie back long hair.
9
Maintain correct balance and footing. Ensure the floor is not slippery and wear non-slip shoes,
9
Secure non stable workpiece with a clamp, vice or other adequate holding device.
8
DO NOT
touch the hot nozzle or the silicon cap.
8
DO NOT
use the glue gun for a task it was not designed to perform.
8
DO NOT
operate the glue gun if any parts are damaged or missing as this may cause failure and/or possible personal injury.
8
DO NOT
hold the workpiece by hand. Use clamps or a vice (not included) to secure the workpiece. Available from your Sealey stockist.
8
DO NOT
get the glue gun wet or use in damp or wet locations or areas where there is condensation.
8
DO NOT
place nozzle close to your face (especially eyes, ears, etc) or other persons or animals.
8
DO NOT
allow children or untrained persons to operate the glue gun.
8
DO NOT
operate the glue gun when you are tired or under the influence of alcohol, drugs or intoxicating medication.
8
DO NOT
get glue on your skin.
8
DO NOT
inhale any vapour given off by the glue.
8
DO NOT
carry the glue gun with your finger on the trigger.
8
DO NOT
use the glue gun where there are flammable liquids, solids or gases such as paint solvents, etc.
8
DO NOT
leave the glue gun operating/heating up unattended.
9
Protect work surface from glue spilt during warm up phase and whilst being used.
9
After use place the glue gun down to cool in a safe manner. Ensure it has cooled down completely before storage.
9
When not in use switch the glue gun off, store the tool in a safe, dry child proof area.
NOTE:
This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities or
lack of experience and knowledge, unless they have been given supervision or instruction concerning the use of the
appliance by a person responsible for their safety. Children should be supervised to ensure that they do not play with the appliance.
2. INTRODUCTION
R
eady to use in 3 minutes. Cordless operation allows use anywhere in the workshop. Composite housing with soft grip for added comfort.
Suitable for glue stick between Ø10-12mm. On/off switch and trigger feed control.
3. SPECIFICATION
Model no
............................................................... CP20VGG
M
ax. running time .........................................................3.5hr
Battery
..........................20V 2Ah - 4 Ah Li-ion (not included)
G
lue stick diameter
................................................. 10-12mm
Consumables ..... AK292/2 - All purpose glue stick pack of 25
Original Language Version
© Jack Sealey Limited
Refer to
instruction
manual
Wear
protective
gloves
Warning!
hot
surface
Wear eye
protection
CP20VGG | Issue:1 06/11/19
