background image

INSTRUCTIONS FOR:  

CORDLESS COB LED FLOODLIGHT 10W

LITHIUM-ION RECHARGEABLE

MODEL No:

 

LED110C

1.1.   GENERAL

 

Ensure the floodlight is correctly charged before initial use.

 

DO NOT

 cover or block the lens during use.

 

DO NOT

 turn the floodlight on when it is being re-charged.

 

DO NOT

 shine directly into your, other person’s or animal’s eyes.

 

DO NOT 

allow children to use the floodlight.

 

DO NOT

 handle or move the floodlight whilst it is being charged.

 

DO NOT

 use the floodlight if you suspect that the battery or the spotlight casing is damaged.

 

DO NOT

 immerse the floodlight in water.

 

Ensure replacement batteries are genuine Sealey batteries of the same rating.

 

Ensure the floodlight is unplugged and allowed to cool before attempting any cleaning or replacement.

 

When not in use store the floodlight in a safe, dry, childproof location.

1.2.   BATTERY SAFETY

 

WARNING! To reduce the risk of burns or fire:

 

,

 

 

DO NOT

 attempt to open, disassemble, modify or service the battery.

 

Ensure the charger is switched off and disconnected from the floodlight before attempting to open the lamp unit.

 

DO NOT

 expose to temperatures above 60°C (140°F). 

 

DO NOT

 crush, puncture, short external contacts or dispose of in fire or water.

 

Replace only with the battery designated for this product.

 

Dispose of the old batteries in accordance with local authority battery regulations. 

DO NOT

 dispose of with regular refuse.

 

If the electrolyte in the cells contacts the skin, wash thoroughly with soap and water. 

 

If the electrolyte in the cells gets into the eyes, rinse thoroughly with cool water and seek immediate medical attention.

1.3.   ELECTRICAL SAFETY 

 

USE ONLY THE SUPPLIED MAINS CHARGER PLUG FOR CONNECTING FLOODLIGHT TO THE MAINS POWER    

 

SUPPLY. ONLY USE THE SUPPLIED ADAPTOR FOR CONNECTING TO A VEHICLE 12V ACCESSORY SOCKET. 

 

WARNING!

 It is the user’s responsibility to read, understand and comply with the following electrical instructions: 

 

You must ensure the risk of electric shock is minimised by the installation of appropriate safety devices. An RCCB (Residual  

 

Current Circuit Breaker) should be incorporated in the main distribution board. We also recommend that an RCD (Residual  

 

Current Device) is used with all electrical products, particularly portable equipment which is plugged into an electrical    

 

supply not protected by an RCCB. 

 

You must

 also read and understand the following instructions concerning electrical safety. 

1.3.1. 

The Electricity At Work Act 1989

 requires all portable electrical appliances, if used on business premises, to be tested by  

 

a qualified electrician, using a Portable Appliance Tester (PAT), at least once a year.

1.3.2.

 The Health & Safety at Work Act 1974 

makes owners of electrical appliances responsible for the safe condition of the  

 

appliance and the safety of the appliance operator. 

If in any doubt about electrical safety, contact a qualified  

 

 electrician. 

1.3.3.

 You must ensure that you:

 

Inspect the charger plug, cable and connector for wear and damage to ensure items are safe before connecting to the   

 

mains power supply. If worn or damaged 

DO NOT

 use.

 

Check cables are always protected against short circuit and overload.

 

Important:

 Check that the voltage marked on the charger plug is the same as the power supply to be used.

 

Uncoil the cable between charger and the floodlight.

 

DO NOT

 pull the charger plug from the mains socket by the lead.

 

DO NOT

 use any other type of charger with this product. 

 

DO NOT

 place the connector into any area of the floodlight except the correct jack inlet socket. 

 

DO NOT

 try to take the charger plug apart.

 

DO NOT

 use the charger plug to charge or power any other electrical item.

 

DO NOT

 get the charger wet, or use in wet, damp conditions (for indoor use only).

 

WARNING!

 

NEVER

 substitute a standard 13Amp 3 pin plug, or any other type of plug, for the charger plug.

Original Language Version

LED110C      Issue: 1 - 11/04/14

© Jack Sealey Limited

IMPORTANT:

 

PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE THE 

PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR 

PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.

Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these 

instructions, and properly maintained, give you years of trouble free performance.

 1.  SAFETY

Reviews: